Diagnose soonFuel starvation causes power loss under load and can strand you. Diagnose soon.
The electrical circuit powering your fuel pump has a fault. If the pump isn't getting power, the car won't start or will die suddenly.
Model notes: Many vehicles have an access panel under the rear seat for the pump - check before dropping the tank. And a pump that dies right after running the tank dry is no coincidence; fuel cools the pump.
Key facts
P0230 means fuel pump primary circuit malfunction. The electrical circuit powering your fuel pump has a fault. If the pump isn't getting power, the car won't start or will die suddenly. WrenchFair's published fair-price range for this repair is $30–$500 parts and $150–$500 labor at independent shops.
WrenchFair rates P0230 a 3-of-5 DIY difficulty (“Fuse and relay checks are easy; pump replacement often means dropping the tank or accessing a hatch under the rear seat.”) with a “Diagnose soon” driveability rating: Fuel starvation causes power loss under load and can strand you. Diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2014 Chevrolet Tahoe (5.3L V8, 6.2L V8) — Fuel pump control module water intrusion (stall):Owner-verified
The fuel pump control module sits underneath the truck near the spare tire, exposed to road spray. It is a sealed plastic box with an RTV gasket — when that seal separates, water gets inside. The module is secured with bolts that are often heavily rusted.
Do this test first: Listen for the pump hum at key-on - silence points at power delivery
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0230 on the 2007–2014 Chevrolet Tahoe — but the community-sourced Fuel pump control module water intrusion (stall) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Fuel pump control module fasteners: verify — Fastener torque not confirmed from a forum source — confirm against factory service info. The module bolts are often rusted; penetrating oil and patience beat snapping them off.
Tips
Know the signature symptom: the engine stalls on turns — one owner's 2009 Tahoe died on every right turn. Water pooled inside the module sloshes during the turn and shorts the fuel pump circuit. If stalling correlates with cornering, this is the prime suspect.
Scan first: codes P069E (FPCM requested MIL), P025A (FPCM control circuit open), P0230, or U0109 (lost communication with FPCM) all point here. One owner logged fuel pressure dropping to 0 PSI on every right turn — that is the telltale.
Do the tilt test before buying parts: with the engine running, unbolt the module and tilt it one way, then the other. If tilting reproduces the stall, the module has water inside. The solved case owner found about a shot glass of water poured out when the module was opened.
The recall context: GM recalled 2009 trucks (27,188 vehicles including Tahoe) for RTV seal separation letting water seep into the module. Even outside the recall, the fix is the same — replace the module, and consider relocating it or adding protection so road spray cannot reach it again.
Do not jump straight to the fuel pump in the tank. If pressure reads normally on a scan tool except during the stall event, the pump itself is fine — it is the control module cutting power.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
no-start
engine dies and won't restart
no fuel pump hum at key-on
check engine light
fuel pump runs with key on
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Blown fuel pump fuse (most common - check first)
Failed fuel pump relay
Failed fuel pump drawing excessive current
Damaged wiring to the pump, especially at the tank
Owner notes linked to P0230: 9 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Listen for the pump hum at key-on - silence points at power delivery
Check the fuel pump fuse and swap the relay with an identical one Tests: Blown fuel pump fuse (most common - check first)
Test for power and ground at the pump connector
If power reaches the pump but it does not run, the pump is dead
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2014 Chevrolet Tahoe: Fuel pump control module water intrusion (stall) — test first, then buy for this job.
The price range below is a national planning range for P0230 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $500
Labor$150 – $500
Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0230 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Fuse and relay checks are easy; pump replacement often means dropping the tank or accessing a hatch under the rear seat.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →