P0190

P0190 on a 2019–2024 Toyota RAV4: Fuel rail pressure sensor circuit malfunction

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0190 on a 2007–2008 Nissan Versa · 2019–2024 Toyota RAV4

DIY difficulty 2/5

The sensor that reports fuel pressure to the computer has an electrical fault. The computer is blind to actual fuel pressure, so performance and mileage suffer.

Model notes: Fuel rail pressure sensors are a common failure point on direct-injection engines - they live at extreme pressure and temperature. Relieve system pressure and work cold.

Key facts

☑ Before you buy parts — check these first:
On your 2019–2024 Toyota RAV4 (2.5L 4-cyl (A25A-FKS)) — Fuel pump replacement: Owner-verified
The XA50 RAV4 has a factory under-rear-seat service access panel — no tank drop is needed. Per Toyota's serviceability documentation for the A25A-FKS/M20A-FKS engines, the fuel suction tube with pump and gauge assembly is removed from inside the cabin: 1. Remove the rear seat cushion assembly. 2. Remove the rear floor service hole cover (LH side). 3. Remove the fuel suction tube with pump and gauge assembly. Clean the top of the pump housing before opening it so debris doesn't fall into the tank, depressurize the fuel system first, and disconnect the 12V negative terminal before unplugging the pump's electrical connector and fuel lines.
Do this test first: Check the pressure PID: stuck at an impossible value suggests sensor or circuit fault
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0190 on the 2019–2024 Toyota RAV4 — but the community-sourced Fuel pump replacement note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: Toyota factory serviceability document (fuel filter/pump access, A25A-FKS) · Owner thread on 2019 RAV4 low-pressure fuel pump recall service

Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0190: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the pressure PID: stuck at an impossible value suggests sensor or circuit fault Tests: Failed fuel rail pressure sensor (most common)
  2. Verify 5V reference and ground at the connector Tests: 5V reference or ground problem
  3. Compare against a mechanical gauge - if the gauge reads normal, the sensor circuit is lying
  4. Relieve fuel pressure before removing the sensor Tests: Failed fuel rail pressure sensor (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2019–2024 Toyota RAV4: Fuel pump replacement — test first, then buy for this job.
The price range below is a national planning range for P0190 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$30 – $500
Labor$150 – $500

Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0190 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — The sensor is usually accessible on the fuel rail; relieve pressure before removal.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →