Diagnose soonFuel starvation causes power loss under load and can strand you. Diagnose soon.
The sensor that reports fuel pressure to the computer has an electrical fault. The computer is blind to actual fuel pressure, so performance and mileage suffer.
Model notes: Fuel rail pressure sensors are a common failure point on direct-injection engines - they live at extreme pressure and temperature. Relieve system pressure and work cold.
Key facts
P0190 means fuel rail pressure sensor circuit malfunction. The sensor that reports fuel pressure to the computer has an electrical fault. The computer is blind to actual fuel pressure, so performance and mileage suffer. WrenchFair's published fair-price range for this repair is $30–$500 parts and $150–$500 labor at independent shops.
WrenchFair rates P0190 a 2-of-5 DIY difficulty (“The sensor is usually accessible on the fuel rail; relieve pressure before removal.”) with a “Diagnose soon” driveability rating: Fuel starvation causes power loss under load and can strand you. Diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2008 Nissan Versa (1.8L MR18DE) — Fuel pump / pressure regulator hard start (NTB-07-094):Factory-documented
Fuel pump and sending unit live inside the tank — access panel under the rear seat. Pump swap is a few-hour driveway job; the TSB-era fix starts with a pressure gauge on the rail.
Do this test first: Check the pressure PID: stuck at an impossible value suggests sensor or circuit fault
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0190 on the 2007–2008 Nissan Versa — but the community-sourced Fuel pump / pressure regulator hard start (NTB-07-094) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Fuel pump / sender assembly fasteners: verify — Torque specs for the lock ring and pump mounting not confirmed from a forum source — confirm against factory service info before torquing.
Tips
The signature symptom is long cranking or repeated no-starts — especially after the car sits — on 2007-2008 Versas, caused by the fuel system losing pressure while parked. A JustAnswer Nissan expert names a service bulletin (one owner complaint cites it as NTB-07-094): the pressure regulator does not let the pump build pressure fast enough.
The documented diagnostic path: drive the car, let it sit 30 minutes, then measure fuel pressure at the rail — one dealer's tech measured 12 psi against a roughly 30-psi pass line and replaced the fuel pump and packing under the bulletin.
Several owners needed two or three pump visits before the failure was pinned down, so do not skip the pressure test — cranking-forever with no codes sends many people down battery and starter rabbit holes.
TrueDelta owners also report dealers first replacing just the regulator and having to come back for the whole pump assembly, so confirm which part your repair covers before you pay.
Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).
Typical time: “The documented diagnostic path: drive the car, let it sit 30 minutes, then measure fuel pressure at the rail — one dealer's tech measured 12 psi against a roughly 30-psi pass line and replaced the fuel pump and packing…” — as written in the note. First-timers often take twice this.
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light
poor performance
hard starting
reduced power mode
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed fuel rail pressure sensor (most common) 2 owner notes link this repair to P0190
Damaged wiring or connector - these live in a hot, vibrating environment
5V reference or ground problem
Corroded terminals
Owner notes linked to P0190: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the pressure PID: stuck at an impossible value suggests sensor or circuit fault Tests: Failed fuel rail pressure sensor (most common)
Verify 5V reference and ground at the connector Tests: 5V reference or ground problem
Compare against a mechanical gauge - if the gauge reads normal, the sensor circuit is lying
Relieve fuel pressure before removing the sensor Tests: Failed fuel rail pressure sensor (most common)
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2007–2008 Nissan Versa: Fuel pump / pressure regulator hard start (NTB-07-094) — test first, then buy for this job.
The price range below is a national planning range for P0190 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $500
Labor$150 – $500
Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0190 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — The sensor is usually accessible on the fuel rail; relieve pressure before removal.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →