P0190

P0190: Fuel rail pressure sensor circuit malfunction

For your specific vehicle: P0190 on a 2007–2008 Nissan Versa · 2019–2024 Toyota RAV4

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The sensor that reports fuel pressure to the computer has an electrical fault. The computer is blind to actual fuel pressure, so performance and mileage suffer.

VW/Audi note (VCDS): A pressure PID that never moves from one fixed value, hot or cold, loaded or idle, is a dead sensor until proven otherwise.
Model notes: Fuel rail pressure sensors are a common failure point on direct-injection engines - they live at extreme pressure and temperature. Relieve system pressure and work cold.

Key facts

Symptoms

Likely causes

Owner notes linked to P0190: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the pressure PID: stuck at an impossible value suggests sensor or circuit fault Tests: Failed fuel rail pressure sensor (most common)
  2. Verify 5V reference and ground at the connector Tests: 5V reference or ground problem
  3. Compare against a mechanical gauge - if the gauge reads normal, the sensor circuit is lying
  4. Relieve fuel pressure before removing the sensor Tests: Failed fuel rail pressure sensor (most common)

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $500
Labor$150 – $500

Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0190 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — The sensor is usually accessible on the fuel rail; relieve pressure before removal.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →