P0116

P0116 on a 2019–2026 Toyota Corolla: Engine coolant temperature sensor circuit range/performance

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0116 on a 2014–2019 Chevrolet Silverado 1500 · 2016–2021 Honda Civic · 2017–2022 Honda CR-V · 2019–2026 Toyota Corolla · 2019–2024 Toyota RAV4

DIY difficulty 1/5

Your coolant temp sensor is giving readings that don't make sense. The car runs rich and wastes gas - cheap sensor, usually an easy swap.

Model notes: Compare the sensor reading to actual coolant temp with an IR thermometer. Inspect the connector for corrosion - coolant can wick into the plug. A stuck-open thermostat can also set this code.

Key facts

☑ Before you buy parts — check these first:
On your 2019–2026 Toyota Corolla (1.8L (2ZR-FAE), 2.0L (M20A-FKS)) — Thermostat replacement: Owner-verified
On the 2.0L M20A-FKS the thermostat is not sold as a standalone insert — it comes as a 'water inlet with thermostat sub-assembly' held by 2 bolts (8 mm heads) to the engine water pump assembly (water inlet housing) at the rear of the engine, below/behind the intake manifold. Drain the coolant, disconnect the No. 2 radiator hose and No. 7 water by-pass hose, then swap the whole sub-assembly. The housing is buried behind the intake manifold, so most of the labor is access, not the swap itself.
Do this test first: Compare the sensor reading to actual coolant temp with an IR thermometer
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0116 on the 2019–2026 Toyota Corolla — but the community-sourced Thermostat replacement note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum / guide · owner forum / guide · owner forum / guide · owner forum / guide

Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0116: 5 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 3 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Compare the sensor reading to actual coolant temp with an IR thermometer Tests: Failing coolant temp sensor
  2. Inspect the connector for green crust - coolant intrusion is common Tests: Corroded connector (coolant wicks into the plug)
  3. Check thermostat operation - a stuck-open thermostat can set this too Tests: Thermostat stuck open confusing the rationality check

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2019–2026 Toyota Corolla: Thermostat replacement — test first, then buy for this job.

Expensive fork: Water pump — if it still overheats or weeps after the thermostat. The price range below is a national planning range for P0116 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$15 – $50
Labor$80 – $180

Sensor is cheap; usually one clip and an O-ring. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0116 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

1 of 5 — Usually one clip and an O-ring.

Watch this repair on YouTube

Parts & tools

Cooling system toolkit — what the job actually takes

Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.

Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →