P0116

P0116 on a 2017–2022 Honda CR-V: Engine coolant temperature sensor circuit range/performance

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0116 on a 2014–2019 Chevrolet Silverado 1500 · 2016–2021 Honda Civic · 2017–2022 Honda CR-V · 2019–2026 Toyota Corolla · 2019–2024 Toyota RAV4

DIY difficulty 1/5

Your coolant temp sensor is giving readings that don't make sense. The car runs rich and wastes gas - cheap sensor, usually an easy swap.

Model notes: Compare the sensor reading to actual coolant temp with an IR thermometer. Inspect the connector for corrosion - coolant can wick into the plug. A stuck-open thermostat can also set this code.

Key facts

☑ Before you buy parts — check these first:
On your 2017–2022 Honda CR-V (1.5L turbo (L15BE)) — Thermostat replacement: Owner-verified
On the 1.5T the thermostat housing (water outlet) sits low on the engine block where the lower radiator hose connects — follow that hose back from the radiator. Drain the radiator through the bottom petcock first, then remove or shift the air intake ducting aside for working room. Unclamp the lower hose at the housing, unbolt the two/three 10mm housing bolts, and keep a catch pan under the housing — the block holds residual coolant that spills when the housing comes off. Tight low-bay access is the pain point; intake-duct removal makes it manageable.
Do this test first: Compare the sensor reading to actual coolant temp with an IR thermometer
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0116 on the 2017–2022 Honda CR-V — but the community-sourced Thermostat replacement note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum / guide · owner forum / guide · owner forum / guide · owner forum / guide

Typical difficulty: Moderate — based on 294 code guides for the cooling repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0116: 5 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 3 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Compare the sensor reading to actual coolant temp with an IR thermometer Tests: Failing coolant temp sensor
  2. Inspect the connector for green crust - coolant intrusion is common Tests: Corroded connector (coolant wicks into the plug)
  3. Check thermostat operation - a stuck-open thermostat can set this too Tests: Thermostat stuck open confusing the rationality check

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2017–2022 Honda CR-V: Thermostat replacement — test first, then buy for this job.

Expensive fork: Water pump — if it still overheats or weeps after the thermostat. The price range below is a national planning range for P0116 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$15 – $50
Labor$80 – $180

Sensor is cheap; usually one clip and an O-ring. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0116 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

1 of 5 — Usually one clip and an O-ring.

Watch this repair on YouTube

Parts & tools

Cooling system toolkit — what the job actually takes

Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.

Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →