P0093

P0093 on a 2011–2016 Chevrolet Silverado HD: Fuel system leak detected - large leak

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0093 on a 2011–2016 Chevrolet Silverado HD · 2011–2016 GMC Sierra HD

DIY difficulty 3/5

The computer thinks a lot of fuel is escaping somewhere - this can be a genuine leak, which is a fire risk, so look for puddles or fuel smell and don't ignore it.

Model notes: Treat every P0093 as a real leak until proven otherwise - a pressure sensor fault is possible but a fuel fire is unforgiving. Inspect first, theorize second.

Key facts

☑ Before you buy parts — check these first:
On your 2011–2016 Chevrolet Silverado HD (6.6L LML Duramax V8 diesel) — Bosch CP4.2 high-pressure fuel pump failure ('CP4 grenade'): Owner-verified
No factory recall for the pump itself on GM trucks (unlike Ford's 6.7L CP4.2 recall). Check your VIN at nhtsa.gov/recalls; the class-action settlement is the only factory-backed relief.
Do this test first: With the engine cold and off, inspect all fuel lines, connections, and injector seals for wetness - do this before starting the engine
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0093 on the 2011–2016 Chevrolet Silverado HD — but the community-sourced Bosch CP4.2 high-pressure fuel pump failure ('CP4 grenade') note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: ChevyTrucks.org: 4 most common Duramax LML engine problems (CP4.2, DEF heater, NOx, DEF pump) · GM Authority: Faulty diesel fuel pump settlement will cost GM $50M (final approval) · TexAgs: CP4 injector pump ticking time bomb - owner discussion, DuramaxForum LML section referral

Typical difficulty: Moderate — based on 483 code guides for the fuel repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0093: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. With the engine cold and off, inspect all fuel lines, connections, and injector seals for wetness - do this before starting the engine Tests: Leaking fuel line, hose, or injector seal (most common - inspect immediately)
  2. Cycle the key to pressurize the system (without starting) and re-inspect for fresh wetness Tests: Leaking fuel line, hose, or injector seal (most common - inspect immediately)
  3. Verify with a mechanical pressure gauge whether pressure truly drops Tests: Faulty rail pressure sensor reporting a false drop
  4. Repair the leak source; do not drive with an active fuel leak

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2011–2016 Chevrolet Silverado HD: Bosch CP4.2 high-pressure fuel pump failure ('CP4 grenade') — test first, then buy for this job.
The price range below is a national planning range for P0093 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$30 – $500
Labor$150 – $500

Filter is cheap; fuel pump replacement is moderate to expensive. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0093 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Safety first: find the leak before driving. Fuel leaks near exhaust or electrics are a fire hazard.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →