P0019

P0019 on a 2011–2014 Ford F-150: Crankshaft-camshaft correlation fault, bank 2 sensor B

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0019 on a 2009–2012 Chevrolet Traverse · 2011–2014 Ford F-150 · 2007–2012 GMC Acadia · 2013–2013 Subaru BRZ

DIY difficulty 3/5

Your engine's computer sees the exhaust camshaft and crankshaft out of sync on the bank-2 side. Check the sensors first (cheap), but a stretched timing chain is the classic mechanical cause.

Model notes: Bank 2 is the side opposite cylinder 1; 'B' is typically the exhaust camshaft.

Key facts

☑ Before you buy parts — check these first:
On your 2011–2014 Ford F-150 (3.5L EcoBoost V6 GTDI) — Timing chain stretch / cold-start rattle: Owner-verified
Front timing cover job — radiator and fan come out for room. Chain, all four VCT units, tensioners, and guides are replaced as a set; this is a full weekend for a DIYer with timing tools.
Do this test first: Inspect the bank 2 exhaust cam sensor and crank sensor wiring for damage or oil contamination
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0019 on the 2011–2014 Ford F-150 — but the community-sourced Timing chain stretch / cold-start rattle note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum (TSB text) · owner forum

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0019: 4 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Inspect the bank 2 exhaust cam sensor and crank sensor wiring for damage or oil contamination Tests: Damaged wiring to the cam or crank sensor
  2. Check for companion correlation codes that point at the timing chain Tests: Stretched timing chain or a belt that skipped a tooth (most common mechanical cause)
  3. Look up service bulletins for your engine
  4. Compare cam and crank waveforms with a scope if available
  5. Inspect timing chain/belt alignment, tensioner condition, and tone-ring security
  6. Verify the bank 2 exhaust VVT actuator parks at zero degrees

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2011–2014 Ford F-150: Timing chain stretch / cold-start rattle — test first, then buy for this job.
The price range below is a national planning range for P0019 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$40 – $700
Labor$100 – $2200

Camshaft or crankshaft position sensor replacement if the sensor is at fault; timing chain, tensioner, and guide replacement if the chain stretched. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0019 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Sensor and wiring checks are easy DIY; confirming a stretched chain means opening up the timing cover.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →