P0018

P0018 on a 2007–2012 GMC Acadia: Crankshaft-camshaft correlation fault, bank 2 sensor A

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P0018 on a 2009–2012 Chevrolet Traverse · 2011–2014 Ford F-150 · 2007–2012 GMC Acadia · 2012–2014 Mercedes-Benz C-Class

DIY difficulty 3/5

Can I drive with P0018?

Can I drive with a P0018 code?

Short trips and gentle driving only, until you know the cause. A stretched chain behind this code can jump teeth and bend valves - diagnose it rather than driving on. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.

How serious is P0018?

Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. A stretched chain behind this code can jump teeth and bend valves - diagnose it rather than driving on.

Will P0018 go away on its own?

The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.

Your engine's computer sees the intake camshaft and crankshaft out of sync on the bank-2 side. Check the sensors first (cheap), but a stretched timing chain is the classic mechanical cause.

Model notes: Bank 2 is the side opposite cylinder 1; 'A' is typically the intake camshaft.

Key facts

☑ Before you buy parts — check these first:
On your 2007–2012 GMC Acadia (3.6L V6 (LY7/LLT)) — Timing chain stretch (P0008/P0009 cam-crank correlation): Owner-verified
Front timing cover job on the 3.6L — the engine uses three chains (one primary, two secondary), and the usual repair replaces all chains, tensioners, and guides as a set. Owners report shops dropping the engine cradle for access, so get a firm quote up front.
Do this test first: Inspect the bank 2 intake cam sensor and crank sensor wiring for damage or oil contamination
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P0018 on the 2007–2012 GMC Acadia — but the community-sourced Timing chain stretch (P0008/P0009 cam-crank correlation) note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum · owner repair data · owner repair data · tech Q&A

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P0018: 4 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Inspect the bank 2 intake cam sensor and crank sensor wiring for damage or oil contamination Tests: Damaged wiring to the cam or crank sensor
  2. Check for companion codes (P0008, P0009, P0016, P0017, P0019) that point at the timing chain Tests: Stretched timing chain or a belt that skipped a tooth (most common mechanical cause)
  3. Look up service bulletins for your engine
  4. Compare cam and crank waveforms with a scope if available - shifted patterns mean sensor or tone-ring trouble Tests: Crankshaft or camshaft tone ring slipped or damaged
  5. Inspect timing chain/belt alignment, tensioner condition, and tone-ring security
  6. Verify the bank 2 intake VVT actuator parks at zero degrees

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2007–2012 GMC Acadia: Timing chain stretch (P0008/P0009 cam-crank correlation) — test first, then buy for this job.
The price range below is a national planning range for P0018 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$40 – $700
Labor$100 – $2200

Camshaft or crankshaft position sensor replacement if the sensor is at fault; timing chain, tensioner, and guide replacement if the chain stretched. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0018 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Sensor and wiring checks are easy DIY; confirming a stretched chain means opening up the timing cover.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →