Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonStalling and hard starting make this unpleasant to live with - diagnose it soon.
Can I drive with P0014?
Can I drive with a P0014 code?
Short trips and gentle driving only, until you know the cause. Stalling and hard starting make this unpleasant to live with - diagnose it soon. If the check-engine light starts flashing, the engine shakes badly, or the car loses significant power, pull over safely and have it towed.
How serious is P0014?
Moderate. WrenchFair rates this one “Diagnose soon” — the car can usually get you home, but driving on it can turn a cheap fix into an expensive one. Stalling and hard starting make this unpleasant to live with - diagnose it soon.
Will P0014 go away on its own?
The warning light can turn off by itself after clean drive cycles, but the code stays stored in the computer's memory and the fault is still there. Clearing it without fixing the cause just buys time — it will come back when the computer re-runs the self-test. Exception: a loose gas cap — tighten it and drive a few days.
Your exhaust camshaft timing is stuck too far advanced on the cylinder-1 side - usually a stuck valve in the variable valve timing system letting oil flow when it shouldn't.
Model notes: Common on GM 2.4L Ecotec, Hyundai/Kia, Nissan. Frequently appears with P0011 on engines where both solenoids sludge up together.
Key facts
P0014 means exhaust camshaft timing over-advanced, bank 1. Your exhaust camshaft timing is stuck too far advanced on the cylinder-1 side - usually a stuck valve in the variable valve timing system letting oil flow when it shouldn't. WrenchFair's published fair-price range for this repair is $40–$200 parts and $80–$300 labor at independent shops.
WrenchFair rates P0014 a 2-of-5 DIY difficulty (“Solenoid replacement plus fresh oil fixes most cases; confirming with live cam-angle data is the key step.”) with a “Diagnose soon” driveability rating: Stalling and hard starting make this unpleasant to live with - diagnose it soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light
hard starting
rough idle
stalling
poor low-speed driveability
Likely causes
VVT oil control solenoid stuck open (most common)
Incorrect camshaft timing from prior timing work
Dirty or wrong-viscosity oil
Worn camshaft phaser stuck advanced
Wiring fault holding the solenoid energized
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check oil level, condition, and viscosity; change if suspect, then clear and retest Tests: Dirty or wrong-viscosity oil
Watch commanded vs. actual exhaust camshaft angle on bank 1 - stuck advanced with no command points to the solenoid or phaser Tests: Worn camshaft phaser stuck advanced
Remove and inspect the bank 1 exhaust VVT solenoid for sludge or a stuck pintle; test or replace Tests: VVT oil control solenoid stuck open (most common)
Check the control wiring for a short holding the solenoid on Tests: Wiring fault holding the solenoid energized
Verify base camshaft timing marks if the solenoid tests good
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $200
Labor$80 – $300
VVT oil control valve (solenoid) replacement, often with an oil change. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P0014 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Solenoid replacement plus fresh oil fixes most cases; confirming with live cam-angle data is the key step.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →