U0687: Lost communication with catalyst temperature bank 2 sensor 2
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonConverter protection is degraded — fix it before an emissions test, and don't ignore new exhaust smells or rattles.
A sensor watches how hot your catalytic converter gets. It went quiet, so the computer can't tell if the converter is working or overheating. Expect a check engine light — the converter itself is usually fine, it's the monitoring that's down.
Key facts
U0687 means lost communication with catalyst temperature bank 2 sensor 2. A sensor watches how hot your catalytic converter gets. It went quiet, so the computer can't tell if the converter is working or overheating. Expect a check engine light — the converter itself is usually fine, it's the monitoring that's down. WrenchFair's published fair-price range for this repair is $60–$180 parts and $100–$200 labor at independent shops.
WrenchFair rates U0687 a 3-of-5 DIY difficulty (“Same story as EGT sensors — penetrating oil and patience on a cold exhaust.”) with a “Diagnose soon” driveability rating: Converter protection is degraded — fix it before an emissions test, and don't ignore new exhaust smells or rattles. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
failed emissions test
no noticeable symptoms
reduced fuel economy
Likely causes
failed catalyst temperature sensor
heat-damaged wiring
corroded connector
exhaust leak near the sensor
engine computer communication fault
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Locate catalyst temperature sensor 2 on bank 2's converter and check the connector. Tests: failed catalyst temperature sensor
Inspect the wiring for heat damage along the exhaust. Tests: heat-damaged wiring
Compare its reading to the other catalyst temp sensor on a cold engine. Tests: failed catalyst temperature sensor
Replace the sensor if wiring is good; clear and retest.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$60 – $180
Labor$100 – $200
Replacing the catalyst temperature sensor. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U0687 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Same story as EGT sensors — penetrating oil and patience on a cold exhaust.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →