U063F: Lost communication with engine coolant flow control valve position sensor
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonFlow control is degraded — watch the temperature gauge and don't drive it overheating.
A valve meters how much coolant flows where, and its position sensor went quiet. The computer can't confirm the valve is doing what it's told. Watch the temperature gauge.
Key facts
U063F means lost communication with engine coolant flow control valve position sensor. A valve meters how much coolant flows where, and its position sensor went quiet. The computer can't confirm the valve is doing what it's told. Watch the temperature gauge. WrenchFair's published fair-price range for this repair is $100–$300 parts and $150–$350 labor at independent shops.
WrenchFair rates U063F a 3-of-5 DIY difficulty (“Coolant work means drain, swap, refill, and bleed — take your time getting the air out.”) with a “Diagnose soon” driveability rating: Flow control is degraded — watch the temperature gauge and don't drive it overheating. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
slow warmup
temperature fluctuations
poor heater performance
Likely causes
failed position sensor
stuck flow control valve
corroded connector
coolant intrusion into the connector
damaged wiring
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the coolant level first. Tests: coolant intrusion into the connector
Locate the flow control valve and inspect its connector for coolant or corrosion. Tests: stuck flow control valve
Command the valve with a scan tool and watch the position reading. Tests: failed position sensor
Replace the valve/sensor assembly if it doesn't respond; refill, bleed, clear, and retest.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$100 – $300
Labor$150 – $350
Replacing the coolant flow control valve. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U063F ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Coolant work means drain, swap, refill, and bleed — take your time getting the air out.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →