U0550

U0550: Invalid Data Received From Side Obstacle Detection Control Module D

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car has a dozen-plus small computers that constantly share data. A side obstacle detection module is sending messages that don't make sense — impossible numbers, frozen values, or garbled frames — so the other computers are ignoring it. Safety helpers that rely on that data may switch themselves off to be safe.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Test the battery and charging system first — low or unstable voltage is the most common cause of garbage data on the network. Tests: weak battery or failing alternator corrupting network data
  2. Scan every module on the vehicle and record all codes; pay special attention to any faults a side obstacle detection module reports about itself or its own sensors. Tests: a sensor feeding a side obstacle detection module reporting bad values
  3. Inspect a side obstacle detection module's connector and wiring for corrosion, loose or pushed-back pins, water intrusion, or rodent damage, and verify its power and ground feeds. Tests: corroded or loose connector at a side obstacle detection module
  4. Clear all codes, drive normally, and rescan — if this code returns together with a side obstacle detection module's own sensor or input codes, fix those inputs first, since bad data in means bad data out. Tests: a sensor feeding a side obstacle detection module reporting bad values
  5. If power, ground, and wiring all test good and a side obstacle detection module keeps broadcasting implausible values, the module itself is suspect — replacement or reprogramming is usually a dealer or specialist job.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$300 – $900
Labor$150 – $350

Repairing the wiring or connector at a side obstacle detection module, or replacing the module. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for U0550 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Checking the battery, connectors, and wiring is solid DIY work; condemning or replacing the module itself usually isn't.

Watch this repair on YouTube

Parts & tools

Electrical diagnosis toolkit — what the job actually takes

Torque specs: Module connectors: hand-tight until they click — never force them.

Pro tip: Check powers AND grounds before condemning a module — most “module failures” are wiring. Disconnect the battery before unplugging modules.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →