P3497

P3497 on a 2011–2017 Honda Odyssey: Cylinder deactivation system (bank 2)

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P3497 on a 2011–2017 Honda Odyssey

DIY difficulty 3/5

Your engine can shut down some cylinders to save gas on the highway, but the computer found a problem with that system on one side of the engine. The most common reason is simply low or old engine oil, because oil pressure is what makes the whole system work.

Key facts

☑ Before you buy parts — check these first:
On your 2011–2017 Honda Odyssey (3.5L J35 V6) — Front spool valve (VVT) oil leak onto alternator: Owner-verified
Front of the engine, by the dipstick area — the spool valve sits right above the alternator. Three 10mm bolts hold the top half; a digital torque wrench or inch-pound torque adapter is needed.
Do this test first: 1. Check the engine oil level and condition immediately - low or wrong-viscosity oil is the number one trigger; top up or change it and retest before anything else.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P3497 on the 2011–2017 Honda Odyssey — but the community-sourced Front spool valve (VVT) oil leak onto alternator note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum · owner forum · guide

Typical difficulty: Moderate — based on 85 code guides for the engine repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Check the engine oil level and condition immediately - low or wrong-viscosity oil is the number one trigger; top up or change it and retest before anything else. Tests: wrong-viscosity or degraded oil
  2. 2. If oil pressure is in doubt, verify it with a mechanical gauge. Tests: low oil pressure from a worn pump or clogged pickup
  3. 3. Research TSBs for your year, model, and engine (Honda/Acura have several published for these codes). Tests: low engine oil level - the leading cause of deactivation codes
  4. 4. Retrieve all codes and freeze-frame data, clear them, and test-drive to see if the code returns or was a one-time event.
  5. 5. Inspect the bank-2 deactivation solenoid connectors and wiring for corrosion, damage, or loose pins.
  6. 6. Test individual solenoids against the vehicle service procedure; suspect the PCM only after oil, wiring, and solenoids all check out.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2011–2017 Honda Odyssey: Front spool valve (VVT) oil leak onto alternator — test first, then buy for this job.
The price range below is a national planning range for P3497 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$40 – $120
Labor$50 – $120

An oil and filter service with the correct viscosity, since low or degraded oil is the most common trigger. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P3497 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — The first checks - oil level, condition, and pressure - are easy driveway work; solenoid replacement varies from simple to intake-removal depending on the engine.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →