Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonCheck the oil before driving further - low oil pressure can turn a simple code into internal engine damage, though the code alone doesn't mean damage has happened.
Your engine can shut down some cylinders to save gas on the highway, but the computer found a problem with that system on one side of the engine. The most common reason is simply low or old engine oil, because oil pressure is what makes the whole system work.
Key facts
P3497 means cylinder deactivation system (bank 2). Your engine can shut down some cylinders to save gas on the highway, but the computer found a problem with that system on one side of the engine. The most common reason is simply low or old engine oil, because oil pressure is what makes the whole system work. WrenchFair's published fair-price range for this repair is $40–$120 parts and $50–$120 labor at independent shops.
WrenchFair rates P3497 a 3-of-5 DIY difficulty (“The first checks - oil level, condition, and pressure - are easy driveway work; solenoid replacement varies from simple to intake-removal depending on the engine.”) with a “Diagnose soon” driveability rating: Check the oil before driving further - low oil pressure can turn a simple code into internal engine damage, though the code alone doesn't mean damage has happened. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
worse fuel economy
reduced engine performance
engine misfire codes stored alongside
rough running at highway cruise
Likely causes
low engine oil level - the leading cause of deactivation codes
wrong-viscosity or degraded oil
low oil pressure from a worn pump or clogged pickup
failed cylinder-deactivation solenoid
open or shorted deactivation circuit wiring
restricted oil passages to the lifters
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
1. Check the engine oil level and condition immediately - low or wrong-viscosity oil is the number one trigger; top up or change it and retest before anything else. Tests: wrong-viscosity or degraded oil
2. If oil pressure is in doubt, verify it with a mechanical gauge. Tests: low oil pressure from a worn pump or clogged pickup
3. Research TSBs for your year, model, and engine (Honda/Acura have several published for these codes). Tests: low engine oil level - the leading cause of deactivation codes
4. Retrieve all codes and freeze-frame data, clear them, and test-drive to see if the code returns or was a one-time event.
5. Inspect the bank-2 deactivation solenoid connectors and wiring for corrosion, damage, or loose pins.
6. Test individual solenoids against the vehicle service procedure; suspect the PCM only after oil, wiring, and solenoids all check out.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $120
Labor$50 – $120
An oil and filter service with the correct viscosity, since low or degraded oil is the most common trigger. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P3497 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — The first checks - oil level, condition, and pressure - are easy driveway work; solenoid replacement varies from simple to intake-removal depending on the engine.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →