P3418

P3418: Cylinder 3 deactivation/intake valve control circuit Range/Performance

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your engine has a system that rests cylinder 3 to save fuel on the highway, using a small oil-driven valve on the intake side. The computer found an electrical problem in that valve's wiring - a degrading solenoid, corroded connector adding resistance, or sluggish oil flow. Check the oil first, because low or dirty oil is the most common reason these codes appear.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. 1. Check the engine oil level and condition first - low, dirty, or wrong-viscosity oil is the top cause of deactivation codes; correct it, clear the code, and retest. Tests: low engine oil level or pressure
  2. 2. Research TSBs for your year, model, and engine - some deactivation faults are known issues with a published fix. Tests: failed cylinder 3 intake-side deactivation solenoid
  3. 3. Locate the cylinder 3 intake-side deactivation solenoid and inspect its wiring and connector for chafing, burns, corrosion, or loose pins. Tests: failed cylinder 3 intake-side deactivation solenoid
  4. 4. Compare the solenoid's response against the vehicle service procedure - a coil drifting out of spec or a valve responding sluggishly points at the solenoid or restricted oil flow. Tests: restricted oil passage to the solenoid
  5. 5. If the circuit tests good, replace the solenoid and clear any blocked oil passages; retest before condemning anything else.
  6. 6. Suspect the ECM only after oil, wiring, and the solenoid are all proven good.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $180
Labor$150 – $500

Replacing the faulty cylinder deactivation solenoid, after ruling out oil level and wiring. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P3418 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Electrical diagnosis is straightforward with a multimeter, but reaching the solenoid can mean removing the intake manifold on some engines.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →