P2D27

P2D27: Coolant Pump F Control Circuit Performance/Stuck Off

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your engine uses small auxiliary electric coolant pumps for things like the turbo, heater, or after-run cooling. The computer says pump f is not performing the way it should.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Read the code and check coolant level and condition first - low coolant makes auxiliary pumps misbehave. Tests: Failed auxiliary pump motor (most common)
  2. Check the pump's fuse and relay (or solid-state driver) before touching the pump. Tests: Blown fuse or failed pump relay/driver
  3. Command the pump on with a scan tool and listen/feel for it running.
  4. Verify power and ground at the pump connector while it is commanded on. Tests: Corroded connector or damaged wiring at the pump
  5. Replace the pump if it has power and ground but will not run properly, then bleed the cooling system and retest.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$120 – $500
Labor$150 – $400

Auxiliary electric coolant pump replacement and cooling-system bleed. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2D27 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Pump replacement is usually a couple of bolts and a hose clamp; the fiddly part is bleeding the air out afterward.

Watch this repair on YouTube

Parts & tools

Cooling system toolkit — what the job actually takes

Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.

Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →