Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonNOx faults can trigger a driver-inducement countdown (reduced power, then no-start) if ignored - diagnose promptly and keep the DEF tank filled with fresh fluid.
Your diesel's NOx trap has absorbed all the sulfur it can handle and cannot clean exhaust properly anymore. Sometimes a forced desulfation (a hot highway regen cycle) revives it; if not, the trap needs replacement - which is not cheap.
Key facts
P2C79 means nOx Adsorber - Sulfur Limit Exceeded. Your diesel's NOx trap has absorbed all the sulfur it can handle and cannot clean exhaust properly anymore. Sometimes a forced desulfation (a hot highway regen cycle) revives it; if not, the trap needs replacement - which is not cheap. WrenchFair's published fair-price range for this repair is $400–$2500 parts and $300–$800 labor at independent shops.
WrenchFair rates P2C79 a 4-of-5 DIY difficulty (“Forced regens need a capable scan tool; trap replacement is expensive exhaust work.”) with a “Diagnose soon” driveability rating: NOx faults can trigger a driver-inducement countdown (reduced power, then no-start) if ignored - diagnose promptly and keep the DEF tank filled with fresh fluid. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light or emissions warning on
reduced fuel economy
possible no-start countdown after ignore period
failed emissions inspection
Likely causes
Sulfur poisoning from fuel with only short-trip driving that never completes desulfation (most common)
Desulfation strategy inhibited by another fault - fix companion codes first
Thermally aged trap that no longer responds to desulfation
Faulty temperature or NOx sensor preventing the regen strategy
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Read the code with a scan tool and save the freeze-frame data, then check for companion codes - when several sensor codes appear together, suspect a shared reference-voltage or ground problem before any single sensor. - fix any companion exhaust-temperature or sensor codes first, since desulfation depends on them. Tests: Desulfation strategy inhibited by another fault - fix companion codes first
Attempt a forced desulfation/service regen with a capable scan tool, followed by a sustained highway drive. Tests: Sulfur poisoning from fuel with only short-trip driving that never completes desulfation…
If NOx storage does not recover, test the trap's efficiency per the service manual.
Replace the NOx adsorber if desulfation cannot restore it, clear the code, and verify on a drive cycle. Tests: Desulfation strategy inhibited by another fault - fix companion codes first
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$400 – $2500
Labor$300 – $800
NOx adsorber desulfation service or trap replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2C79 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Forced regens need a capable scan tool; trap replacement is expensive exhaust work.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →