P2000

P2000: NOx trap efficiency below threshold (bank 1)

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your diesel has a special filter that catches harmful nitrogen oxide gases, and the one on the cylinder-1 side of the engine is not working well enough. The computer figured this out by comparing sensors before and after the filter. You will usually just see a check engine light, possibly with weaker performance.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your vehicle - this code has known fixes on several diesels. Tests: Low, contaminated, or wrong-spec diesel exhaust fluid / reductant in the SCR tank (most…
  2. Confirm the DEF/reductant tank is full and the fluid is fresh and meets spec; contaminated or missing fluid is the most common cause. Tests: Low, contaminated, or wrong-spec diesel exhaust fluid / reductant in the SCR tank (most…
  3. Inspect all SCR and NOx-sensor wiring and connectors, especially where harnesses run near hot exhaust parts or sharp heat shields, on bank 1. Tests: Low, contaminated, or wrong-spec diesel exhaust fluid / reductant in the SCR tank (most…
  4. Check the exhaust for leaks upstream of the NOx trap and repair them, since leaks skew the sensor readings. Tests: Exhaust leak upstream of the NOx trap
  5. Verify the EGR system works and repair any stored EGR codes first - a disabled EGR is a frequent root cause.
  6. With a scan tool, watch the bank 1 pre- and post-trap NOx sensor data at idle and normal operating temperature; if a sensor is dead, check its fuse, power, and ground before condemning the trap itself.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$60 – $2500
Labor$150 – $600

DEF refill plus NOx sensor or dosing system repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2000 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — The easy checks are DEF level/quality, wiring, and exhaust leaks; interpreting NOx sensor data and diagnosing the dosing system needs a capable scan tool and the factory service manual.

Watch this repair on YouTube

Parts & tools

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →