P2C36: Crankcase Pressure Sensor B Circuit Intermittent/Erratic
DIY difficulty 2/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonDo not ignore crankcase pressure faults long-term - excessive pressure pushes oil past seals and gaskets.
Your engine monitors pressure inside the crankcase to make sure the breather system is working, and the secondary sensor is giving a bad reading. The usual suspects are the sensor itself, a clogged breather, or wiring. Worth fixing - crankcase pressure problems can push oil past seals.
Key facts
P2C36 means crankcase Pressure Sensor B Circuit Intermittent/Erratic. Your engine monitors pressure inside the crankcase to make sure the breather system is working, and the secondary sensor is giving a bad reading. The usual suspects are the sensor itself, a clogged breather, or wiring. Worth fixing - crankcase pressure problems can push oil past seals. WrenchFair's published fair-price range for this repair is $40–$150 parts and $80–$200 labor at independent shops.
WrenchFair rates P2C36 a 2-of-5 DIY difficulty (“Breather inspection plus a sensor swap - basic hand tools and a scan tool.”) with a “Diagnose soon” driveability rating: Do not ignore crankcase pressure faults long-term - excessive pressure pushes oil past seals and gaskets. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
possible oil leaks at seals
rough idle
increased oil consumption
Likely causes
Failed crankcase pressure sensor B (most common)
Clogged crankcase breather or PCV path skewing the reading
Damaged wiring or oil-contaminated connector
Excessive blowby from worn rings overwhelming the breather (check if pressure reads genuinely high)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Read the code with a scan tool and save the freeze-frame data, then check for companion codes - when several sensor codes appear together, suspect a shared reference-voltage or ground problem before any single sensor. Tests: Excessive blowby from worn rings overwhelming the breather (check if pressure reads…
Check the breather/PCV path for clogging before condemning the sensor - a blocked breather makes pressure read wrong. Tests: Excessive blowby from worn rings overwhelming the breather (check if pressure reads…
Inspect the sensor and its connector for oil contamination and damage. Tests: Damaged wiring or oil-contaminated connector
Compare the sensor reading against expected values per the service manual. Tests: Clogged crankcase breather or PCV path skewing the reading
Clean or replace the breather components, or replace the sensor, then clear the code and verify.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $150
Labor$80 – $200
Crankcase pressure sensor B replacement or breather service. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2C36 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
2 of 5 — Breather inspection plus a sensor swap - basic hand tools and a scan tool.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →