P2C32

P2C32: Crankcase Pressure Sensor B Circuit

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your engine monitors pressure inside the crankcase to make sure the breather system is working, and the secondary sensor is giving a bad reading. The usual suspects are the sensor itself, a clogged breather, or wiring. Worth fixing - crankcase pressure problems can push oil past seals.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Read the code with a scan tool and save the freeze-frame data, then check for companion codes - when several sensor codes appear together, suspect a shared reference-voltage or ground problem before any single sensor. Tests: Excessive blowby from worn rings overwhelming the breather (check if pressure reads…
  2. Check the breather/PCV path for clogging before condemning the sensor - a blocked breather makes pressure read wrong. Tests: Excessive blowby from worn rings overwhelming the breather (check if pressure reads…
  3. Inspect the sensor and its connector for oil contamination and damage. Tests: Damaged wiring or oil-contaminated connector
  4. Compare the sensor reading against expected values per the service manual. Tests: Clogged crankcase breather or PCV path skewing the reading
  5. Clean or replace the breather components, or replace the sensor, then clear the code and verify.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $150
Labor$80 – $200

Crankcase pressure sensor B replacement or breather service. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2C32 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Breather inspection plus a sensor swap - basic hand tools and a scan tool.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →