P2A0D

P2A0D: Manifold absolute pressure sensor B circuit high

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your engine has a second intake-pressure sensor (MAP B), and the computer found a high signal on it. The engine still runs, but it is guessing at airflow instead of measuring it, so expect slightly worse performance and economy until it is fixed.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Read the code with a scan tool and save the freeze-frame data, then check for companion codes - when several sensor codes appear together, suspect a shared reference-voltage or ground problem before any single sensor.
  2. Locate MAP sensor B (bank 2 side or secondary intake - confirm in the service manual) and inspect its connector, wiring, and vacuum hose for cracks, kinks, or disconnection. Tests: Connector pins corroded or pushed back
  3. Compare MAP B live data against MAP A (or calculated load) at key-on-engine-off and at idle - a large disagreement points at the sensor or its plumbing.
  4. Wiggle-test the harness with the engine running; if the reading jumps, repair the wiring rather than replacing the sensor.
  5. Replace the sensor if the wiring and plumbing check out, then clear the code and verify the readings agree on a test drive.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $120
Labor$80 – $160

MAP sensor B replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2A0D ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — MAP sensors are usually one bolt and one connector; the real work is the diagnosis, which is scan-tool and multimeter work.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →