P2752: Intermediate Shaft Speed Sensor C Circuit Intermittent
DIY difficulty 4/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonModerately severe - erratic shift-timing data can damage the transmission. Diagnose any transmission issue as soon as possible.
The intermediate shaft speed sensor C signal is intermittent or erratic - shifting problems may come and go.
Key facts
P2752 means intermediate Shaft Speed Sensor C Circuit Intermittent. The intermediate shaft speed sensor C signal is intermittent or erratic - shifting problems may come and go. WrenchFair's published fair-price range for this repair is $50–$300 parts and $100–$500 labor at independent shops.
WrenchFair rates P2752 a 4-of-5 DIY difficulty (“Intermittent faults are the hardest to pin down - wiggle tests and noting when it occurs help, but the fault may hide during testing.”) with a “Diagnose soon” driveability rating: Moderately severe - erratic shift-timing data can damage the transmission. Diagnose any transmission issue as soon as possible. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
hard shifting
numerous instrument panel lights illuminated
poor driveability
erratic engine speed
Likely causes
Defective or damaged intermediate shaft speed sensor
Electrical fault in the wires between the speed sensor and modules
Internal ECM and/or TCM issue
Other related sensors/solenoids damaged or defective (input shaft speed sensor, output shaft sensor, shift solenoid, etc.)
Dirty or low automatic transmission fluid
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 8 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the transmission fluid level first - make sure the fluid is clean and adequately filled. Burnt-smelling ATF is a sign a full transmission service (filter, gasket, fluid) is needed. Tests: Dirty or low automatic transmission fluid
Locate the intermediate shaft speed sensor (often mounted directly on the transmission housing); make sure the sensor and connector are in good condition and fully connected. Tests: Defective or damaged intermediate shaft speed sensor
Remove and clean an accessible speed sensor - dirt or metal shavings on the pickup alter its readings. Use brake cleaner and a rag. Tests: Defective or damaged intermediate shaft speed sensor
Check for rubbing marks on the sensor pickup - this may indicate inadequate spacing between the reluctor ring and pickup. Tests: Electrical fault in the wires between the speed sensor and modules
Perform a wiggle test on the harness while watching the sensor signal with a scanner or meter to catch the fault.
Note when the fault occurs (hot, cold, on bumps) - intermittent faults often correlate with heat or vibration.
Test the sensor and its circuit with a multimeter against the manufacturer specifications, measuring at the sensor pins and at the corresponding ECM/TCM connector pins.
If the sensor tests good, suspect wiring or an internal ECM/TCM issue - this may need a specialist.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$50 – $300
Labor$100 – $500
Intermediate shaft speed sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2752 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Intermittent faults are the hardest to pin down - wiggle tests and noting when it occurs help, but the fault may hide during testing.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →