P2750

P2750: Intermediate Shaft Speed Sensor C Circuit Range Performance

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The intermediate shaft speed sensor C signal is out of range - the computer gets unreliable shift-timing data.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the transmission fluid level first - make sure the fluid is clean and adequately filled. Burnt-smelling ATF is a sign a full transmission service (filter, gasket, fluid) is needed. Tests: Dirty or low automatic transmission fluid
  2. Locate the intermediate shaft speed sensor (often mounted directly on the transmission housing); make sure the sensor and connector are in good condition and fully connected. Tests: Defective or damaged intermediate shaft speed sensor
  3. Remove and clean an accessible speed sensor - dirt or metal shavings on the pickup alter its readings. Use brake cleaner and a rag. Tests: Defective or damaged intermediate shaft speed sensor
  4. Check for rubbing marks on the sensor pickup - this may indicate inadequate spacing between the reluctor ring and pickup; refer to manufacturer procedures for adjusting the pickup/reluctor gap. Tests: Dirty sensor pickup or incorrect reluctor gap
  5. Test the sensor and its circuit with a multimeter against the manufacturer specifications, measuring at the sensor pins and at the corresponding ECM/TCM connector pins to verify harness integrity.
  6. If the sensor tests good, suspect wiring or an internal ECM/TCM issue - this may need a specialist.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $300
Labor$100 – $500

Intermediate shaft speed sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2750 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Fluid check, sensor cleaning, and wiring inspection are DIY; locating the sensor and testing circuits needs a service manual.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →