P2742

P2742: Transmission Fluid Temperature Sensor B Circuit Low Input

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The transmission fluid temperature sensor B signal is shorted low - the PCM thinks the transmission is overheating.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 7 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Visually inspect the transmission fluid temperature sensor and wiring for damaged or shorted wiring; repair, clear, and see if it returns. Tests: Faulty transmission fluid temperature sensor
  2. Check Technical Service Bulletins for the issue.
  3. Use a scan tool to monitor the transmission temperature data parameter - if it reads abnormally high on a cold engine, the circuit is shorted. Tests: Faulty transmission fluid temperature sensor
  4. Disconnect the TFT sensor: the scan tool value should drop to a very low value. Then jumper across the terminals: if the tool shows a very high temperature, the wiring and PCM are good, so the sensor itself is likely bad. Tests: Faulty transmission fluid temperature sensor
  5. Test the sensor: disconnect it and measure resistance between its two terminals while the engine warms up - resistance should decrease smoothly; a near-zero reading suggests a shorted sensor.
  6. Check the reference side: with ignition on, verify 5-volt reference from the PCM at the sensor terminals; with ignition off, check continuity between sensor and PCM terminals.
  7. If everything in the circuit checks out, the transmission itself may have a problem - especially if other transmission codes are set with this one.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $300
Labor$100 – $600

Transmission fluid temperature sensor replacement (often inside the pan). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2742 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Wiring checks and sensor tests are DIY; the sensor is often inside the pan (fluid drain, gasket) - moderate effort.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →