Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonStarts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing.
The E pressure control solenoid works intermittently - shifting problems may come and go.
Key facts
P2726 means pressure Control Solenoid E Intermittent. The E pressure control solenoid works intermittently - shifting problems may come and go. WrenchFair's published fair-price range for this repair is $60–$900 parts and $150–$1500 labor at independent shops.
WrenchFair rates P2726 a 5-of-5 DIY difficulty (“Intermittent faults are the hardest to pin down - wiggle tests and noting when it occurs help, but the fault may hide during testing.”) with a “Diagnose soon” driveability rating: Starts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
vehicle enters limp mode
transmission slips when shifting
transmission overheating
transmission catches in gear
decreased fuel economy
possible misfire-like symptoms
check engine light illuminated
Likely causes
Defective pressure control solenoid
Dirty or contaminated fluid
Dirty or clogged transmission filter
Defective transmission pump
Defective transmission valve body
Restricted hydraulic passages
Corroded or damaged connector
Faulty or damaged wiring
Faulty PCM
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 8 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Research Technical Service Bulletins for the specific vehicle by year, model, and transmission. Tests: Dirty or clogged transmission filter
Check vehicle records to verify the last time the filter and fluid were changed.
Check the fluid level and examine the fluid condition for contamination.
Perform a detailed visual inspection of the wiring for obvious defects, paying attention to spots that move or flex; check connectors and connections for security, corrosion, and damaged pins - including all wiring to the pressure control solenoids, transmission pump, and PCM. Tests: Defective pressure control solenoid
Perform a wiggle test on the harness while watching the solenoid circuit with a scanner or meter to catch the fault.
Note when the fault occurs (hot, cold, on bumps) - intermittent faults often correlate with heat or vibration.
Beware of misdiagnosis: engine misfire, transmission pump problem, internal transmission problem, or driveline problem can mimic this code.
Advanced diagnosis needs a digital multimeter and the vehicle-specific troubleshooting guidelines (voltage and fluid pressure requirements vary by model). Perform continuity checks with power removed - normal wiring/connections should read 0 ohms.
Typical price range
Parts$60 – $900
Labor$150 – $1500
Fluid/filter service or pressure control solenoid replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2726 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
5 of 5 — Intermittent faults are the hardest to pin down - wiggle tests and noting when it occurs help, but the fault may hide during testing.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →