Diagnose soonStarts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing.
The E pressure control solenoid is not performing or is stuck off - wrong line pressure means slipping or limp mode.
Key facts
P2723 means pressure Control Solenoid E Performance or Stuck Off. The E pressure control solenoid is not performing or is stuck off - wrong line pressure means slipping or limp mode. WrenchFair's published fair-price range for this repair is $60–$900 parts and $150–$1500 labor at independent shops.
WrenchFair rates P2723 a 4-of-5 DIY difficulty (“Fluid/filter service and wiring checks are DIY; pressure solenoid or valve body work needs pan removal and transmission-specific knowledge.”) with a “Diagnose soon” driveability rating: Starts moderate but can progress to severe rapidly - wrong line pressure burns clutches. Fix promptly, avoid hard acceleration and towing. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2007–2009 GMC Acadia (3.6L V6) — 3-5-R wave plate failure (no reverse, 3rd/5th flare):Owner-verified
Transmission-out job — the 3-5-R clutch wave plate lives inside the 6T70/6T75 case. Diagnosis is the DIY-friendly part; the repair is a transmission rebuild or replacement best left to a specialist.
Do this test first: Research Technical Service Bulletins for the specific vehicle by year, model, and transmission.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2723 on the 2007–2009 GMC Acadia — but the community-sourced 3-5-R wave plate failure (no reverse, 3rd/5th flare) note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Transmission internal fasteners: verify — Specialist rebuild — no owner-documented torque specs; confirm against factory service info.
Tips
Learn the pattern: SES light plus no reverse, and/or a slip/flare or harsh shift in 3rd and 5th gears. The classic DTC is P0776 (clutch pressure control solenoid 2 stuck off); P0777, P2723, P0717, P0716, P2715, and P2714 can set from the same failure.
The cause per GM bulletin 09-07-30-012B is a broken 3-5-R (35R) clutch wave plate that lets the apply piston over-stroke and leak — typically not before about 20,000 miles. Debris from the breakage can also foul the speed sensors and other clutches.
The documented fix is the updated waved clutch plate (P/N 24254103) with a full cleanup: debris cleaned from the whole transmission, plus a new pump fluid filter and control-solenoid filter plate. Skipping the cleanup is how repeat failures happen.
One owner caught it early and had a dealer rebuild for under $1,500 with GM assistance — so stop driving it the moment reverse disappears or 3rd/5th starts flaring, and call a dealer about goodwill help before authorizing a $4,000-$5,000 replacement.
If a shop does the rebuild, the plate's installation orientation matters (GM guidance: rounded edge of the internal splines toward the 35R piston) to prevent a repeat failure.
A full replacement transmission is the common outcome once debris has circulated — multiple owners report reman units after the wave plate disintegrated, so early diagnosis genuinely saves money here.
Typical difficulty: Moderate — based on 306 code guides for the transmission repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
vehicle enters limp mode
transmission slips when shifting
transmission overheating
transmission catches in gear
decreased fuel economy
possible misfire-like symptoms
check engine light illuminated
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Defective pressure control solenoid
Dirty or contaminated fluid
Dirty or clogged transmission filter
Defective transmission pump
Defective transmission valve body
Restricted hydraulic passages
Corroded or damaged connector
Faulty or damaged wiring
Faulty PCM
Owner notes linked to P2723: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 7 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Research Technical Service Bulletins for the specific vehicle by year, model, and transmission. Tests: Dirty or clogged transmission filter
Check vehicle records to verify the last time the filter and fluid were changed.
Check the fluid level and examine the fluid condition for contamination.
Perform a detailed visual inspection of the wiring for obvious defects; check connectors and connections for security, corrosion, and damaged pins - including all wiring to the pressure control solenoids, transmission pump, and PCM. Tests: Defective pressure control solenoid
Common repairs: changing the fluid and filter, replacing the faulty pressure control solenoid, repairing or replacing the transmission pump or valve body, flushing to clean passages, cleaning connector corrosion, repairing wiring.
Beware of misdiagnosis: engine misfire, transmission pump problem, internal transmission problem, or driveline problem can mimic this code.
Advanced diagnosis needs a digital multimeter and the vehicle-specific troubleshooting guidelines (voltage and fluid pressure requirements vary by model). Perform continuity checks with power removed - normal wiring/connections should read 0 ohms.
Most likely job on your 2007–2009 GMC Acadia: 3-5-R wave plate failure (no reverse, 3rd/5th flare) — test first, then buy for this job.
The price range below is a national planning range for P2723 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$60 – $900
Labor$150 – $1500
Fluid/filter service or pressure control solenoid replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2723 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Fluid/filter service and wiring checks are DIY; pressure solenoid or valve body work needs pan removal and transmission-specific knowledge.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →