P2669

P2669: Actuator Supply Voltage B Circuit/open

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The power feed for a set of actuators is open - most often this affects the transmission.

Model notes: On some European models this code can relate to the EVAP system rather than the transmission - let the symptoms guide the diagnostic direction.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 7 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Research Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
  2. Research the designation for B within the circuit for the specific vehicle using OEM service information.
  3. Clear the codes with a scanner and drive the vehicle until it becomes active again.
  4. Locate the correct circuit/harness and inspect it for damage - it may be routed under the vehicle where road debris, dirt, or ice can damage it; repair any open or chafed wires (solder and shrink wrap, replace connectors with OEM). Tests: Open or chafed wire
  5. Disconnect and inspect the involved connectors for bent or damaged pins; look for burn-through of insulation from high resistance.
  6. If the actuator is externally accessible, verify its integrity with a multimeter per the service manual - values outside spec mean the actuator is defective.
  7. Inspect the ECM and TCM for water intrusion and corrosion (green powder); ECM diagnosis should be left to a licensed technician.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $300
Labor$100 – $400

Wiring repair or actuator replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2669 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Visual inspection and wire repair are DIY; pinpointing the correct B circuit and testing the actuator/ECM/TCM needs OEM service data.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →