P261C

P261C: Coolant Pump B Control Circuit Low

For your specific vehicle: P261C on a 2010–2015 Toyota Prius

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The second electric coolant pump circuit is shorted low - the pump may not run, so the engine can overheat.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 9 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
  2. Locate Coolant Pump B (usually mounted to the front or top of the engine, inside a wheel well, or against the bulkhead). Tests: Open in the circuit to the coolant pump
  3. Inspect the pump connector, wiring, and the pump relay and its connections for damage, corrosion, burn spots, or melted plastic - relays and their connections are the most common concern. Tests: Failed or corroded pump relay or relay connections
  4. Clean terminals with electrical contact cleaner and a plastic bristle brush, dry, and apply electrical grease.
  5. Clear the code with a scan tool; if it does not return, the connection was the problem.
  6. If it returns, disconnect the pump harness and check pump motor resistance with a digital multimeter against manufacturer specs - open or shorted means replace the coolant pump.
  7. With the pump commanded on (scan tool actuator function), verify 12 V at the pump power supply circuit; repair wiring from the PCM or relay if missing.
  8. Verify a good ground at the pump with a test light while actuating it; wiggle the harness to catch intermittent connections.
  9. If all tests pass, the coolant pump has likely failed - replace it. PCM failure is unlikely.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $400
Labor$100 – $400

Electric coolant pump replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P261C ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Visual inspection and relay checks are DIY; pump resistance and circuit tests need a multimeter; PCM is shop-level.

Watch this repair on YouTube

Parts & tools

Cooling system toolkit — what the job actually takes

Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.

Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →