P2605

P2605: Intake Air Heater B Circuit Open

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The diesel intake air heater B circuit has a break - expect hard cold starts and rough idling when cold.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Research Technical Service Bulletins for the specific vehicle by year, model, and engine - it may be a known issue with a known fix.
  2. Refer to a vehicle-specific repair manual to determine which is the B circuit. Tests: Faulty or damaged wiring (open circuit)
  3. Note the intake air heater circuit may not activate automatically if ambient or engine temperature is above the manufacturer limit; it should activate if commanded ON with a scanner or if power is applied manually. Tests: Faulty temperature sensor
  4. Basic checks: verify the heater element is turning ON (do not touch the element or heat shield), verify the blower motor turns ON, visually inspect circuit connections and wiring for obvious defects, inspect air ducts for damage, and check electrical connections for security and corrosion. Tests: Faulty heater element relay
  5. Use a digital multimeter and the vehicle-specific troubleshooting guidelines to check power and ground to each component in sequence - if voltage is correct to a component that is not functioning, that component is most likely defective; if power is not available, run continuity checks to find the open.
  6. Common repairs: replacing the heater element, temperature sensor, heater element relay, blower motor, or damaged air ducts; cleaning corrosion from connectors; repairing or replacing wiring; flashing or replacing the PCM.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $350
Labor$80 – $400

Intake air heater element or relay replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2605 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Basic visual checks and relay swaps are DIY; pinpointing the open in the circuit needs a multimeter and vehicle-specific wiring data.

Watch this repair on YouTube

Parts & tools

Electrical diagnosis toolkit — what the job actually takes

Torque specs: Module connectors: hand-tight until they click — never force them.

Pro tip: Check powers AND grounds before condemning a module — most “module failures” are wiring. Disconnect the battery before unplugging modules.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →