P2562

P2562: Turbo Boost Control Position Sensor Circuit

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The turbo boost sensor circuit has an electrical fault - expect poor performance and hesitation.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for Technical Service Bulletins for the specific vehicle - it may be a known issue with a known fix.
  2. Locate the TBCPS sensor (usually screwed or bolted into the turbocharger housing). Tests: Open in the signal circuit to the TBCPS sensor
  3. Visually inspect the connector and wiring for scraping, rubbing, bare wires, burn spots, or melted plastic.
  4. Pull the connector apart and inspect the terminals for burning or green corrosion; clean with electrical contact cleaner and a plastic bristle brush, dry, and apply electrical grease.
  5. Clear the code with a scan tool and see if it returns - if it does not, the connection was the problem.
  6. If it returns, test the TBCPS power and ground circuits with a digital multimeter KOEO per manufacturer specs (12 V or 5 V).
  7. If power and ground pass, test the signal wire (should read 5 V disconnected); repair the open if not.
  8. If all tests pass, the TBCPS sensor has likely failed - replace it. PCM failure is unlikely.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $200
Labor$80 – $250

Turbo boost control position sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2562 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Visual inspection and connector cleaning are DIY; multimeter circuit tests need basic electrical skills; PCM is shop-level.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →