Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonThe truck should still drive normally, but the PTO-driven equipment may fail without warning. Repair before relying on the equipment for work.
The second PTO speed selector signal keeps cutting in and out - expect the dump bed or plow to work sometimes and fail other times.
Key facts
P255E means pto Speed Selector Sensor/switch 2 Circuit Intermittent/erratic. The second PTO speed selector signal keeps cutting in and out - expect the dump bed or plow to work sometimes and fail other times. WrenchFair's published fair-price range for this repair is $40–$300 parts and $100–$300 labor at independent shops.
WrenchFair rates P255E a 3-of-5 DIY difficulty (“Wiring inspection, wiggle tests, and connector cleaning are DIY; PCM diagnosis is shop-level.”) with a “Diagnose soon” driveability rating: The truck should still drive normally, but the PTO-driven equipment may fail without warning. Repair before relying on the equipment for work. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
auxiliary PTO equipment works intermittently or not at all
PTO system disabled
check engine light illuminated
intermittent or no response from PTO controls
Likely causes
Defective PTO sensor
Loose or corroded connector (intermittent contact)
Faulty or damaged wiring (rubbing or chafing)
PTO speed selector switch failure
Defective fuse or fuse-able link
Defective PCM
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 7 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Research Technical Service Bulletins for the specific vehicle year, model, and engine/transmission configuration.
Locate all components of the PTO speed selector 2 circuit and inspect wiring for scraping, rubbing, bare wires, or burn spots. Tests: Faulty or damaged wiring (rubbing or chafing)
Wiggle the harness and connectors while watching the sensor signal to reproduce the intermittent fault. Tests: Loose or corroded connector (intermittent contact)
Check all connectors and connections for security, corrosion, and damaged pins, including PCM connectors. Tests: Loose or corroded connector (intermittent contact)
Check the fuse or fusible link in the circuit.
With a digital multimeter and the specific technical references, test the PTO speed selector sensor/switch 2.
If wiring and sensor are good, have a qualified shop test the PCM.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $300
Labor$100 – $300
PTO speed selector sensor/switch replacement or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P255E ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Wiring inspection, wiggle tests, and connector cleaning are DIY; PCM diagnosis is shop-level.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →