P2457

P2457: Exhaust Gas Recirculation Cooling System Performance

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Diesel-only: the EGR cooler is not cooling exhaust gases as well as it should - the PCM sees the EGR temperature running too close to the downpipe temperature.

Model notes: Reported on 2014 VW Passat 2.0 TDI; diesel vehicles from Ford, Dodge, GMC, Chevrolet, Mercedes, VW.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for TSBs matching the code, vehicle, and symptoms - a known fix can shortcut the diagnosis.
  2. Diagnose and repair any DPF-related codes first - DPF back pressure issues contribute to P2457. Tests: Inadequate DPF causing exhaust back pressure issues
  3. Visually inspect wiring harnesses and connectors for the EGR temperature sensor and exhaust temperature sensor; examine harnesses near hot exhaust pipes and manifolds. Tests: Faulty exhaust temperature sensor
  4. Load test the battery and check terminals, cables, and alternator output.
  5. Record all stored codes and freeze-frame data, then clear codes and test drive.
  6. Observe scanner data stream to determine whether actual EGR cooling is taking place; if temperature inputs are within specs, suspect a defective PCM or programming error.
  7. Test the EGR temperature sensor per manufacturer specs; replace if it fails. If good, test its circuitry (disconnect controllers first); repair or replace open or shorted circuits.
  8. Use an infrared thermometer to check exhaust gas temperature at the EGR cooler inlet and outlet at operating temperature; compare with specs and replace faulty components.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$80 – $500
Labor$100 – $400

EGR temperature sensor or EGR cooler replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2457 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Coolant check, visual wiring inspection, and freeze-frame/code recording are DIY-friendly; sensor and circuit testing per specs is intermediate.

Watch this repair on YouTube

Parts & tools

EGR toolkit — what the job actually takes

Torque specs: Typically 20–30 Nm into iron, less into aluminum — verify spec.

Pro tip: Clean the passages, not just the valve — a new valve on clogged passages throws the same code.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →