P2336

P2336: Cylinder 1 Above Knock Threshold

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The knock sensor on cylinder 1 is reporting engine knock above normal limits - either real knocking or a faulty sensor.

Model notes: Applies to Mercedes-Benz, Ford, Sprinter, Nissan. The knock sensor typically threads into the engine block - use caution with hot coolant or oil when removing it.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Make sure the engine is filled to the proper level with the appropriate oil and that the oil is in good working order; eliminate actual engine noise (spark knock) before diagnosing the code. Tests: Engine noise caused by component failure
  2. Research technical service bulletins for the specific vehicle first.
  3. Retrieve stored codes and freeze frame data, record them, clear codes, and test-drive.
  4. Visually inspect related wiring and connectors; repair or replace wiring that has been cut, burned, or damaged. Tests: Open or shorted wiring or wiring connectors
  5. Disconnect the PCM and use the DVOM to check continuity in the knock sensor circuit from the sensor back to the PCM connector.
  6. The code is usually attributable to a PCM programming error, a defective knock sensor, or actual spark knock.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $100
Labor$100 – $300

Knock sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2336 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Knock sensor replacement often requires reaching under the intake manifold; continuity testing with a DVOM is intermediate.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →