P2311

P2311: ignition coil D secondary circuit

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The high-voltage side of ignition coil D (spark plug boot/wire side) is not delivering spark properly - that cylinder is misfiring.

Model notes: Anecdotally most commonly found on Jeep and Dodge vehicles. Refer to a manufacturer-specific guide to determine which is the D circuit. Reported on Dodge Challenger R/T, 2004 Mercedes CL203 Sport Coupe.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Research technical service bulletins for the specific vehicle first.
  2. Retrieve stored codes and freeze frame data, record them, clear codes, and test-drive.
  3. Visually inspect related wiring and connectors; repair or replace wiring that has been cut, burned, or damaged. Tests: Open or shorted wiring or wiring connectors (wildlife damage)
  4. If the vehicle is beyond its recommended tune-up interval, suspect bad spark plug wires/boots; treat torn, burnt, or fluid-contaminated boots as defective. Tests: Bad spark plug wire or boot
  5. Gain access to the junction between the ignition coil and the spark plug wire and check for high-energy ignition at the spark plug (carefully, engine running): HEI at the plug but poor running suggests a bad plug or PCM error; HEI at the coil but not the plug suggests a bad wire or boot; no HEI at the coil suggests a defective coil.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $150
Labor$50 – $200

Spark plug/wire/boot or ignition coil replacement (may be repaired by a maintenance tune-up). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2311 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Spark plug/wire/boot replacement is a routine tune-up job; tracing wiring faults is intermediate.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →