P2307

P2307: ignition coil C primary control circuit high

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The control circuit for ignition coil C (cylinder 3 area) is reading too high voltage - that cylinder is not firing properly.

Model notes: Refer to a manufacturer-specific guide to determine which is the C circuit. Reported on 2013 Ford F-150 3.5L EcoBoost. Applies to Jeep, Ford, VW, Mini, Dodge, Chrysler, Chevrolet.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Research technical service bulletins for the specific vehicle first.
  2. Retrieve stored codes and freeze frame data, record them, clear codes, and test-drive.
  3. Visually inspect related wiring and connectors; repair or replace wiring that has been cut, burned, or damaged (wiring on top of the engine is often damaged by wildlife). Tests: Open or shorted wiring or wiring connectors (wildlife damage)
  4. Use the DVOM to test voltage and ground circuits at the ignition coil; if no voltage, check the system relay and related fuses. Tests: Defective ignition coil
  5. If voltage and ground are present at the coil, test the corresponding ground circuit at the PCM connector with the engine running; a ground pulse there suggests an open circuit between the coil and the PCM, while no ground pulse suggests a defective PCM or programming error.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$40 – $150
Labor$50 – $150

Ignition coil replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2307 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Ignition coil testing and replacement is intermediate; wiring diagnosis with a DVOM is straightforward.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →