P2305

P2305: ignition coil B secondary circuit

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The high-voltage side of ignition coil B (spark plug boot/wire side) is not delivering spark properly - that cylinder is misfiring.

Model notes: Anecdotally most commonly found on Jeep and Dodge vehicles. Refer to a manufacturer-specific guide to determine which is the B circuit. Reported on 2013 Chrysler 200, Dodge Ram 1500 4.7L, 2004 Dodge Neon.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Research technical service bulletins for the specific vehicle first.
  2. Retrieve stored codes and freeze frame data, record them, clear codes, and test-drive.
  3. Visually inspect related wiring and connectors; repair or replace wiring that has been cut, burned, or damaged. Tests: Open or shorted wiring or wiring connectors (wildlife damage)
  4. If the vehicle is beyond its recommended tune-up interval, suspect bad spark plug wires/boots; treat torn, burnt, or fluid-contaminated boots as defective. Tests: Bad spark plug wire or boot
  5. Gain access to the junction between the ignition coil and the spark plug wire and check for high-energy ignition at the spark plug (carefully, engine running): HEI at the plug but poor running suggests a bad plug or PCM error; HEI at the coil but not the plug suggests a bad wire or boot; no HEI at the coil suggests a defective coil.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $150
Labor$50 – $200

Spark plug/wire/boot or ignition coil replacement (may be repaired by a maintenance tune-up). National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2305 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Spark plug/wire/boot replacement is a routine tune-up job; tracing wiring faults is intermediate.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →