P2282

P2282: Air Leak Between Throttle Body and Intake Valves

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

There is an air leak between the throttle body and the intake valves - usually a large vacuum leak at the intake manifold or its gasket.

Model notes: Seen on 2005 Saturn Vue 6-cylinder and 2017 Ford Fiesta ST. Applies to Vauxhall, Chevrolet, Suzuki, Saturn, Ford.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Research technical service bulletins for the specific vehicle first.
  2. With the engine running, carefully check the intake manifold area for signs of a vacuum leak - a leak large enough to set this code will likely be very evident; do not forget the EGR valve and PCV valve. Tests: Large vacuum leak on or near the intake manifold
  3. If MAF codes accompany the P2282, inspect the MAF sensor hot wire for debris and clean only per manufacturer recommendations.
  4. Retrieve all stored codes and freeze frame data, record them, then clear codes and test-drive until readiness or the code resets.
  5. If the code resets, test the MAF and MAP sensors per manufacturer specifications using the DVOM, then test system circuits with the voltage drop method.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$30 – $200
Labor$100 – $400

Intake manifold or throttle body gasket replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2282 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — A leak this size is usually audible; intake manifold gasket replacement is intermediate to advanced depending on the vehicle.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →