P2276

P2276: O2 sensor signal stuck lean bank 2 sensor 3

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The second downstream O2 sensor (after the second catalytic converter) on bank 2 is stuck reading lean - it thinks there is too much oxygen in the exhaust.

Model notes: Seen on 2016 Jaguar F-Type R. Vehicle brands include Ford, Mazda, Jaguar, Jeep, Land Rover.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Visually inspect the wiring and connectors for corrosion, rubbed/chafed/bent wires, bent/loose pins, burnt appearance, or crossed wires.
  2. Check for exhaust leaks near the O2 sensor and repair as necessary. Tests: Exhaust leak near O2 sensor
  3. Using a DVOM set to ohms, check harness connectors for resistance and compare to manufacturer specifications.
  4. With the engine at normal operating temperature in closed loop, monitor bank 2 sensor 3 readings on the scan tool - a stuck-lean rear HO2S will likely sit at 0V; revving the engine should cause the voltage to change. Tests: Contaminated or failed HO2S (sensor 3)
  5. If replacing the O2 sensor, buy an OEM one for best results; inspect a removed sensor for fuel, engine oil, and coolant contamination.
  6. If the sensor checks out, test fuel pressure, inspect the purge solenoid valve, fuel injectors, and coolant passages for leaks.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $200
Labor$50 – $150

Oxygen sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2276 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Visual inspection and downstream O2 sensor replacement are intermediate work; live-data monitoring requires a scan tool.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: O2 sensors: typically 35–50 Nm (26–37 lb-ft) — verify spec. A dab of nickel anti-seize on the threads; keep it off the sensor tip.

Pro tip: Route the new sensor’s harness exactly like the old one — melted wires on the exhaust are the number-one comeback.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →