P222C

P222C: Barometric Pressure Sensor B Low

DIY difficulty 2/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your second atmospheric pressure sensor (sensor B) is reading too low, throwing off the air-fuel mixture.

Model notes: Applies to Chevy, Mazda, Volvo, Acura, Honda, BMW, Isuzu, Mercedes-Benz, Cadillac, Hyundai, Saab, Ford, GMC.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 5 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Locate the BAP sensor on your vehicle; locations vary significantly, so identifying the correct sensor is the highest priority. Inspect it for physical damage, considering its surroundings (heat, vibration, road debris). Tests: Heat damage
  2. Verify the sensor connector is fully seated; engine-mounted sensors can loosen from vibration. Tests: Defective or damaged electrical connector
  3. Disconnect the battery before disconnecting any sensor to avoid damaging electrical spikes. Tests: Defective or damaged electrical connector
  4. Check that nothing is obstructing the sensor, which can cause false atmospheric pressure readings. Tests: Defective or damaged BAP (barometric air pressure) sensor
  5. With the connector disconnected, use a multimeter to compare the sensor electrical values against manufacturer-specified values. Values out of range indicate a defective sensor; replace it following proper removal/replacement procedures.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $180
Labor$75 – $250

Barometric pressure sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P222C ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Sensor location varies; replacement is straightforward once found, but verify with manufacturer-specified electrical values.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →