Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonSevere: an incorrect air-fuel ratio from insufficient fuel or excessive air can damage the engine and catalyst. Rectify as quickly as possible.
The far side of your engine is getting a different air-fuel mix than the rest, and the computer cannot bring them back into balance.
Model notes: Reported on 2010 Chevy Silverado 4.8L, 2014 GMC Sierra 5.3L, Toyota, Dodge, Ford, Honda, Jeep, Chevrolet, GMC, Ram.
Key facts
P219B means bank 2 Air/fuel Ratio Imbalance. The far side of your engine is getting a different air-fuel mix than the rest, and the computer cannot bring them back into balance. WrenchFair's published fair-price range for this repair is $40–$250 parts and $75–$300 labor at independent shops.
WrenchFair rates P219B a 3-of-5 DIY difficulty (“Vacuum and exhaust leaks can be DIY-found, but diagnosing cylinder-to-cylinder imbalance often needs scan data analysis.”) with a “Diagnose soon” driveability rating: Severe: an incorrect air-fuel ratio from insufficient fuel or excessive air can damage the engine and catalyst. Rectify as quickly as possible. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
diminished fuel efficiency
lack of general engine performance
stored misfire codes or lean/rich exhaust codes
check engine light
Likely causes
Engine vacuum leak (large)
Defective oxygen sensor/s
Burnt, chafed, broken, or disconnected wiring or connectors
Engine exhaust leaks
Faulty mass air flow or manifold air pressure sensor
Bad fuel pump or clogged fuel filter
Fuel injector imbalance
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 5 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Address any stored misfire, throttle position, MAP, or MAF codes before diagnosing P219B; the engine must run smoothly and any rich or lean condition must be repaired first.
Search for TSBs matching the code, vehicle, and symptoms - a known fix can shortcut the diagnosis.
Record all stored codes and freeze-frame data, then clear codes and test drive until the code returns or the PCM enters readiness mode.
Visually inspect related wiring and connectors; repair any wiring that is cut, burned, or damaged. Tests: Burnt, chafed, broken, or disconnected wiring or connectors
With the engine at operating temperature and idling in park/neutral, watch oxygen sensor data on the scanner data stream - normally functioning sensors cycle continuously; sensors that fail to cycle adequately with a healthy engine should be considered defective.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$40 – $250
Labor$75 – $300
Vacuum/exhaust leak repair or oxygen sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P219B ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Vacuum and exhaust leaks can be DIY-found, but diagnosing cylinder-to-cylinder imbalance often needs scan data analysis.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →