P2193

P2193: System too lean at higher load bank 2

DIY difficulty 3/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

The engine is running too lean at higher load on bank 2 - too much air, not enough fuel.

Model notes: Common on European and Asian fuel-injected vehicles since 2010, including VW, Audi, Mercedes, BMW/Mini, Hyundai, Mazda, Kia, and Infiniti. Code P2191 is the same code for Bank 1.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 8 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your vehicle.
  2. Diagnose any fuel or fuel system related codes first - misdiagnosis can occur otherwise. Tests: Fuel system issue - fuel pressure, fuel pressure regulator, or fuel injectors
  3. Ensure there are no intake or exhaust leaks. Tests: Exhaust leak before the AFR/O2 sensor
  4. Locate the bank 2 AFR/O2 sensor and MAF sensor; visually inspect connectors and wiring for chafing, corrosion, or bare wires.
  5. Clear the codes and see if P2193 returns - if not, connections were likely the problem.
  6. Test the MAF sensor signal voltage against manufacturer specifications; replace if it fails.
  7. Monitor the AFR/O2 sensor; if it continually indicates lean, investigate fuel pressure, injectors, and EVAP purge valve.
  8. Suspect the PCM only after all other issues are eliminated.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$0 – $300
Labor$100 – $300

Vacuum leak repair, MAF or AFR/O2 sensor replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2193 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

3 of 5 — Checking for intake/exhaust leaks and inspecting sensors is DIY-friendly; fuel pressure and sensor circuit testing is intermediate.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →