P2185: Engine coolant temperature sensor 2 circuit high input
DIY difficulty 3/5
Print shop one-pagerTake this page to the shop — causes, fair prices, and sharp questions on one sheet.
Diagnose soonCan cause poor drivability and rich running - diagnose within a reasonable time frame.
The second coolant temperature sensor is reporting an impossibly cold reading - usually a bad sensor.
Model notes: Seen on VW, Ford, Dodge, Chevrolet, and other vehicles with two coolant temperature sensors.
Key facts
P2185 means engine coolant temperature sensor 2 circuit high input. The second coolant temperature sensor is reporting an impossibly cold reading - usually a bad sensor. WrenchFair's published fair-price range for this repair is $20–$100 parts and $80–$150 labor at independent shops.
WrenchFair rates P2185 a 3-of-5 DIY difficulty (“Replacing the ECT sensor is DIY-friendly; circuit diagnosis with a DVOM is intermediate.”) with a “Diagnose soon” driveability rating: Can cause poor drivability and rich running - diagnose within a reasonable time frame. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Symptoms
check engine light on
very poor fuel economy
no start condition
vehicle may start but run very poorly, blowing black smoke
misfiring
Likely causes
Bad ECT sensor #2 (most likely)
Bad connection at the #2 ECT sensor
Open in the ground circuit between the sensor and the PCM
Short in the voltage feed between the sensor and the PCM
Bad PCM (less likely)
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 7 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check for technical service bulletins for your vehicle.
Using a scan tool, check the reading of the #2 coolant sensor - if it reads a logical number, the problem is likely intermittent. Tests: Bad ECT sensor #2 (most likely)
Perform a wiggle test by wiggling the connector and harness while watching the reading on the scan tool - drop-outs indicate a bad connection. Tests: Bad connection at the #2 ECT sensor
If the reading is illogical, check the resistance of the temperature sensor - if out of specs, replace it.
Check for 5V reference voltage and ground presence at the connector.
If 5V ref or ground is missing at the sensor but present at the PCM, repair the open or short between the PCM and sensor.
Suspect the PCM only after all other possibilities are ruled out.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Typical price range
Parts$20 – $100
Labor$80 – $150
ECT sensor #2 replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2185 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Replacing the ECT sensor is DIY-friendly; circuit diagnosis with a DVOM is intermediate.
Torque specs: Thermostat housing bolts: typically 8–12 Nm. Aluminum threads strip easily — verify spec and use a torque wrench.
Pro tip: Bleed the cooling system per the factory procedure after refilling, or trapped air will overheat the engine and fake a “still broken” reading.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →