Diagnose soonRunning lean from under-fueled cylinders can cause engine damage over time; address promptly.
The power supply circuit to one group of fuel injectors is broken or open - those injectors may not be getting the voltage they need to fire.
Model notes: Commonly reported on Dodge Ram (Cummins), GMC/Chevrolet (Duramax), VW, Audi, Ford (Powerstroke), and Mercedes Sprinter diesels.
Key facts
P2149 means fuel injector group B circuit open. The power supply circuit to one group of fuel injectors is broken or open - those injectors may not be getting the voltage they need to fire. WrenchFair's published fair-price range for this repair is $100–$800 parts and $150–$500 labor at independent shops.
WrenchFair rates P2149 a 4-of-5 DIY difficulty (“Locating the injector group and inspecting wiring is DIY-friendly; injector replacement and circuit testing are intermediate work.”) with a “Diagnose soon” driveability rating: Running lean from under-fueled cylinders can cause engine damage over time; address promptly. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2004–2005 GMC Sierra HD (6.6L LLY Duramax V8 diesel) — LLY injector harness connector failure, cylinders #2 and #7:Owner-verified
Connector kits available from GM dealers and diesel specialty vendors; the repair is basic hand tools plus a scan tool to confirm codes.
Do this test first: Determine which injector group the manufacturer means by group B (bank 2, paired injectors, etc.).
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2149 on the 2004–2005 GMC Sierra HD — but the community-sourced LLY injector harness connector failure, cylinders #2 and #7 note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Injector connector repair: verify — Electrical repair; no torque spec applies. Seat connectors fully and route the harness clear of chafe points.
Tips
On the 2004.5-2005 LLY Duramax, the #2 and #7 fuel injector connectors are a known failure point. When a connector opens intermittently, the truck suddenly loses power, knocks loudly, and barely rolls; owners report it feels like the engine is crippled. Restarting the truck often clears it temporarily because the fault is vibration-dependent.
The ECM's response makes it dramatic: when it detects the injector circuit fault (P0202, P0207, P2146, P2149), it shuts down half the injectors to keep the engine balanced, which is what causes the heavy knocking and power loss. Do not keep driving it hard in that state.
The root causes documented by owners and vendors: sloppy terminal crimps, poorly seated wire insulators, and terminals that fracture from engine vibration. The wiring can also chafe where the harness routes over the valve covers, so inspect the loom for rub-through before condemning the connector.
GM released a connector repair kit covering the #2 and #7 injectors (two connectors, brackets, and instructions), available through Chevrolet/GMC dealers. Aftermarket vendors also sell upgraded pigtail connectors built with genuine Bosch housings and high-temp GXL wire as a permanent fix.
The owner workaround known as the 'ice pick trick' (gently re-tensioning the connector pins) is widely reported to buy time, but the real fix is replacing the connectors. Check and clean the pins at every injector connector while you are in there.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light on
erratic engine performance
misfire
reduced fuel economy
erratic idle
excessive smoke
engine noise
lack of power
reduced throttle response
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Defective or damaged fuel injector(s)
Damaged wiring harness
Internal wiring malfunction
Connector problem - corroded or loose terminals
Internal ECM issue
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Determine which injector group the manufacturer means by group B (bank 2, paired injectors, etc.). Tests: Defective or damaged fuel injector(s)
Locate the injectors and their circuits - may require removing engine covers. Tests: Defective or damaged fuel injector(s)
Inspect the harness for broken wires, worn-away insulation, and water trapped in injector valleys. Tests: Defective or damaged fuel injector(s)
Clean connectors with electrical contact cleaner and ensure connector tabs seal properly. Tests: Connector problem - corroded or loose terminals
Perform a continuity test with a multimeter set to resistance - test each wire from end to end.
Follow the vehicle-specific service manual circuit tests for the injector supply voltage.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2004–2005 GMC Sierra HD: LLY injector harness connector failure, cylinders #2 and #7 — test first, then buy for this job.
The price range below is a national planning range for P2149 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$100 – $800
Labor$150 – $500
Injector replacement, wiring harness repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2149 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Locating the injector group and inspecting wiring is DIY-friendly; injector replacement and circuit testing are intermediate work.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →