Diagnose soonFuel starvation causes power loss under load and can strand you. Diagnose soon.
The power feed to one group of fuel injectors is broken, so those cylinders get no fuel. The engine will run very rough or barely run.
Model notes: On diesels this code often traces to injector harness chafing where it passes through the valve cover - inspect carefully before replacing expensive injectors.
Key facts
P2146 means fuel injector group A supply voltage circuit/open. The power feed to one group of fuel injectors is broken, so those cylinders get no fuel. The engine will run very rough or barely run. WrenchFair's published fair-price range for this repair is $30–$500 parts and $150–$500 labor at independent shops.
WrenchFair rates P2146 a 4-of-5 DIY difficulty (“Grouped injector circuits need wiring diagrams and careful testing - one shorted injector can kill the whole group.”) with a “Diagnose soon” driveability rating: Fuel starvation causes power loss under load and can strand you. Diagnose soon. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
On your 2004–2005 GMC Sierra HD (6.6L LLY Duramax V8 diesel) — LLY injector harness connector failure, cylinders #2 and #7:Owner-verified
Connector kits available from GM dealers and diesel specialty vendors; the repair is basic hand tools plus a scan tool to confirm codes.
Do this test first: Check the fuse and relay feeding the injector group
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2146 on the 2004–2005 GMC Sierra HD — but the community-sourced LLY injector harness connector failure, cylinders #2 and #7 note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Injector connector repair: verify — Electrical repair; no torque spec applies. Seat connectors fully and route the harness clear of chafe points.
Tips
On the 2004.5-2005 LLY Duramax, the #2 and #7 fuel injector connectors are a known failure point. When a connector opens intermittently, the truck suddenly loses power, knocks loudly, and barely rolls; owners report it feels like the engine is crippled. Restarting the truck often clears it temporarily because the fault is vibration-dependent.
The ECM's response makes it dramatic: when it detects the injector circuit fault (P0202, P0207, P2146, P2149), it shuts down half the injectors to keep the engine balanced, which is what causes the heavy knocking and power loss. Do not keep driving it hard in that state.
The root causes documented by owners and vendors: sloppy terminal crimps, poorly seated wire insulators, and terminals that fracture from engine vibration. The wiring can also chafe where the harness routes over the valve covers, so inspect the loom for rub-through before condemning the connector.
GM released a connector repair kit covering the #2 and #7 injectors (two connectors, brackets, and instructions), available through Chevrolet/GMC dealers. Aftermarket vendors also sell upgraded pigtail connectors built with genuine Bosch housings and high-temp GXL wire as a permanent fix.
The owner workaround known as the 'ice pick trick' (gently re-tensioning the connector pins) is widely reported to buy time, but the real fix is replacing the connectors. Check and clean the pins at every injector connector while you are in there.
Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
severe rough running
dead cylinders on one bank
no-start on some engines
check engine light
reduced fuel economy
excessive smoke
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Failed injector driver or fuse feeding the group (most common)
Damaged harness to the injector group
Corroded connector at the valve cover or injector harness
Shorted injector taking down the group supply
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 4 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Check the fuse and relay feeding the injector group Tests: Failed injector driver or fuse feeding the group (most common)
Unplug injectors one at a time - if the circuit comes alive with one unplugged, that injector is shorted Tests: Shorted injector taking down the group supply
Test each injector's resistance in the group
Trace the group supply wiring for opens or chafing Tests: Shorted injector taking down the group supply
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2004–2005 GMC Sierra HD: LLY injector harness connector failure, cylinders #2 and #7 — test first, then buy for this job.
The price range below is a national planning range for P2146 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$30 – $500
Labor$150 – $500
Wiring or connector repair is most common; injector replacement if the injector tests bad. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2146 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
4 of 5 — Grouped injector circuits need wiring diagrams and careful testing - one shorted injector can kill the whole group.
Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.
As an Amazon Associate, WrenchFair earns from qualifying purchases.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →