P2146

P2146 on a 2004–2005 GMC Sierra HD: Fuel injector group A supply voltage circuit/open

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P2146 on a 2004–2005 GMC Sierra HD

DIY difficulty 4/5

The power feed to one group of fuel injectors is broken, so those cylinders get no fuel. The engine will run very rough or barely run.

Model notes: On diesels this code often traces to injector harness chafing where it passes through the valve cover - inspect carefully before replacing expensive injectors.

Key facts

☑ Before you buy parts — check these first:
On your 2004–2005 GMC Sierra HD (6.6L LLY Duramax V8 diesel) — LLY injector harness connector failure, cylinders #2 and #7: Owner-verified
Connector kits available from GM dealers and diesel specialty vendors; the repair is basic hand tools plus a scan tool to confirm codes.
Do this test first: Check the fuse and relay feeding the injector group
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2146 on the 2004–2005 GMC Sierra HD — but the community-sourced LLY injector harness connector failure, cylinders #2 and #7 note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: JustAnswer: 2004 LLY P2146/P0207, #7 injector connector failure and dealer kit · DuramaxDiesels.com: p0207, p2146 thread (LLY harness diagnosis) · Bonanza/Turboparts: LLY injector connector listing describing the #2/#7 failure

Typical difficulty: Moderate — based on 1374 code guides for the electrical repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check the fuse and relay feeding the injector group Tests: Failed injector driver or fuse feeding the group (most common)
  2. Unplug injectors one at a time - if the circuit comes alive with one unplugged, that injector is shorted Tests: Shorted injector taking down the group supply
  3. Test each injector's resistance in the group
  4. Trace the group supply wiring for opens or chafing Tests: Shorted injector taking down the group supply

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2004–2005 GMC Sierra HD: LLY injector harness connector failure, cylinders #2 and #7 — test first, then buy for this job.
The price range below is a national planning range for P2146 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$30 – $500
Labor$150 – $500

Wiring or connector repair is most common; injector replacement if the injector tests bad. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2146 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Grouped injector circuits need wiring diagrams and careful testing - one shorted injector can kill the whole group.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →