P213E

P213E: Fuel Injection System Fault - Forced Engine Shutdown

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

Your car detected a fuel system fault bad enough to shut the engine off to protect it.

Model notes: Seen on Chevrolet, Land Rover, GM.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 7 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Use caution when diagnosing high pressure fuel system codes; follow manufacturer recommendations, use appropriate safety equipment, and open the fuel system only in a well-ventilated area away from open flame or spark. Tests: Faulty fuel pressure sensor
  2. Obtain testing specifications and procedures for the fuel system and components plus wiring diagrams and diagnostic flow charts.
  3. Clear the code first; the fuel pump cannot be activated until the code is cleared.
  4. Connect the scanner, retrieve all stored codes and freeze frame data, write them down, clear the codes, and attempt to start the engine.
  5. Have one person cycle the ignition key on while a second person looks for fuel leaks near the fuel injection rail and fuel injectors; repair any leak found and drive until the PCM enters readiness mode or P213E resets.
  6. If no leaks are found, use the fuel pressure tester near the fuel injection rail per manufacturer guidelines. Insufficient pressure suggests a fuel filter or pump problem; excessive pressure suggests a fuel pressure regulator problem.
  7. If fuel pressure is within specs and no leaks are present, follow manufacturer recommendations for testing fuel pressure sensors, the fuel pressure regulator, and the fuel volume regulator.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$50 – $600
Labor$100 – $450

Fuel leak repair, injector, sensor, or regulator replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P213E ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Fuel system diagnosis is advanced; high-pressure diesel fuel systems should be serviced by qualified personnel only.

Watch this repair on YouTube

Parts & tools

Fuel system toolkit — what the job actually takes

Torque specs: Fuel rail bolts: typically 8–12 Nm — verify spec.

Pro tip: Relieve fuel pressure first (pull the pump fuse, run the engine until it stalls). Work cold, battery disconnected, extinguisher within reach — no power tools near open fuel.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →