P2112

P2112 on a 2016–2016 Ford Explorer: Throttle actuator control system - stuck closed

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.
For your specific vehicle: P2112 on a 2016–2016 Ford Explorer · 2013–2020 Ford Fusion

DIY difficulty 2/5

The throttle is stuck shut and won't open when you press the gas. The engine is starved for air, so the car barely accelerates.

Model notes: Vehicles that idle extensively (delivery, security patrol) build throttle carbon fastest - periodic throttle cleaning prevents this code.

Key facts

☑ Before you buy parts — check these first:
On your 2016–2016 Ford Explorer (3.5L Ti-VCT V6, 2.3L EcoBoost I4, 2.0L EcoBoost I4) — Electronic throttle body failure — wrench light and limp mode: Owner-verified
On top of the engine under the plastic cover — four bolts and an electrical connector. Owners call it a 15-minute swap once diagnosed.
Do this test first: Inspect the throttle bore - a carbon ring at the blade edge is the classic cause
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2112 on the 2016–2016 Ford Explorer — but the community-sourced Electronic throttle body failure — wrench light and limp mode note above covers an owner-reported fix.
Fixed yours? Report it — you'll help the next owner.

Torque specs

Tips

Sources: owner forum · owner forum · press

Typical difficulty: Moderate — based on 307 code guides for the intake repair area (an area-level estimate, not this exact job).

How notes are verified: Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.

No owner reports yet

Symptoms

Likely causes

What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.

Owner notes linked to P2112: 2 across 1 repair — these are counts of owner-written notes, not odds of fixing your car.

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 4 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Inspect the throttle bore - a carbon ring at the blade edge is the classic cause Tests: Severe carbon buildup gluing the blade shut (most common)
  2. Clean and verify the blade moves freely through its full range by hand (key off)
  3. Command the throttle with a scan tool and confirm it follows commands Tests: Failed throttle actuator motor
  4. Replace the assembly if the motor cannot move a clean, free blade

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Most likely job on your 2016–2016 Ford Explorer: Electronic throttle body failure — wrench light and limp mode — test first, then buy for this job.
The price range below is a national planning range for P2112 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers.
If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.

Typical price range

Parts$10 – $250
Labor$80 – $250

Cleaning is nearly free; throttle body replacement costs more. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2112 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

2 of 5 — Carbon is the usual cause and cleaning is straightforward; motor failure means throttle body replacement.

Watch this repair on YouTube

Parts & tools

Intake & throttle toolkit — what the job actually takes

Torque specs: Throttle body bolts: typically 8–12 Nm — verify spec.

Pro tip: Some cars need a throttle relearn after cleaning (scan tool or battery-disconnect procedure), or the idle will hunt.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →