Diagnose soonThe PCM is forcing limited RPM - the vehicle is in limp mode with little or no throttle response.
Your car's computer detected a problem elsewhere and is limiting engine RPM as a safety measure - this code is the messenger, not the cause.
Key facts
P2110 means throttle actuator control system forced limited RPM. Your car's computer detected a problem elsewhere and is limiting engine RPM as a safety measure - this code is the messenger, not the cause. WrenchFair's published fair-price range for this repair is $100–$500 parts and $100–$400 labor at independent shops.
WrenchFair rates P2110 a 3-of-5 DIY difficulty (“Reading all codes and researching TSBs is DIY-friendly; the underlying fault may need professional diagnosis.”) with a “Diagnose soon” driveability rating: The PCM is forcing limited RPM - the vehicle is in limp mode with little or no throttle response. These are this guide’s own published ratings.
For labor context, WrenchFair's methodology page cites two published numbers: about half of US independent shops charge $120–$159/hr (PartsTech survey of 752 shops, fall 2024), and the national average posted mechanical rate was $163/hr in June 2026 (NABR LaborRateHero). Multiply either band by a quote's labor hours to judge whether its labor line is in range.
Service bulletins: 1,575 factory bulletins on file for this vehicle (mostly Electrical System, Equipment, Structure) — see the latest ones
On your 2019–2026 Ram 1500 (5.7L HEMI V8) — Throttle body cleaning:Owner-verified
The DT 5.7L HEMI uses a fully electronic throttle body held to the intake manifold by 4 bolts plus an electrical connector; pull the air intake tube off first for access. For cleaning, the factory service info forbids spray (carb) cleaners and silicone lubricants — wipe the bore and plate with brake cleaner applied to a cloth, never sprayed directly into the throttle body. Critically, do not force the throttle plate open while cleaning: owners report that throws the PCM calibration off and causes surging or very high idle.
Do this test first: Research technical service bulletins for your vehicle and this code.
→ Passes: that cause is ruled out — run the next test in the diagnostic path below.
→ Fails: fix what failed — that’s your cause. Clear the code and re-test before buying anything else.
No owner fix reports yet for P2110 on the 2019–2026 Ram 1500 — but the community-sourced Throttle body cleaning note above covers an owner-reported fix. Fixed yours? Report it — you'll help the next owner.
Torque specs
Throttle body mounting bolts (4): verify — Confirm against factory service info for the 5.7L HEMI before torquing.
Tips
5.7L V-8 throttle body reset procedure (from factory service info) after removal/cleaning/replacement: disconnect negative battery cable ~90 seconds, reconnect, turn key ON but DO NOT crank, leave ON at least 10 seconds so the PCM learns throttle body parameters, turn key OFF, then crank and start normally.
On replacement some owners also do the 'pedal to the floor' relearn: after reconnecting the battery, key ON, wait for dash lights to go out, then slowly depress and release the accelerator.
If the red lightning-bolt (ETC) warning appears after cleaning, disconnect and clean the throttle body electrical connector and pins with electrical contact cleaner and add dielectric grease before condemning the throttle body.
If cleaning doesn't fix a red lightning-bolt/limp condition, the throttle body (or the accelerator pedal position sensor, which talks to the PCM that drives the throttle body) is the likely next suspect — watch pedal-position data for glitches on a scan tool.
Never polish or port the throttle plate area; owners have destroyed sensitive throttle bodies attempting it, with P2110 forced-limited-RPM faults after.
Typical difficulty: Moderate — based on 307 code guides for the intake repair area (an area-level estimate, not this exact job).
How notes are verified:Robbie-tested — Robbie did this repair on his own car and confirmed the fix himself. Owner-verified — community repair procedure with 2+ cited sources. Factory-documented — drawn from a factory TSB, recall, or campaign document; a factory procedure, not an owner-tested fix. Community-reported — single-source or otherwise unverified; treat as a lead, not a verdict.
No owner reports yet
Symptoms
check engine light on
reduced engine power / limp mode with limited rpm
little or no throttle response
abs light may be illuminated
automatic transmission may not shift
additional codes present
Likely causes
What usually pays the bill on this car, most common first — but work the diagnostic path above cheapest-first. Test order and bill order aren’t the same thing.
Another stored fault the PCM considers safety-related (most common) - see co-occurring codes
Engine overheating or coolant leaks
EGR valve malfunction
Mass airflow sensor malfunction
ABS, traction control, or stability control failure
Automatic transmission problem
Abnormal system voltage
Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →
Before you buy the part — 6 checks
Work these checks before spending money — each one rules a cause in or out, cheapest first.
Research technical service bulletins for your vehicle and this code.
Complete a full PCM scan and list all other stored trouble codes. Tests: Another stored fault the PCM considers safety-related (most common) - see co-occurring…
Diagnose and repair the OTHER codes first - P2110 is informational and set because of them.
Once all other codes are cleared, see if P2110 returns.
If P2110 persists with no other codes, evaluate the throttle actuator and PCM - inspect all wiring and connections.
Do not replace the throttle actuator or PCM before the underlying fault is fixed.
No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.
Most likely job on your 2019–2026 Ram 1500: Throttle body cleaning — test first, then buy for this job.
The price range below is a national planning range for P2110 on this vehicle — not a quote: it spans the common job at the low end to the expensive fork at the high end. 0 owner invoices on this generation — treat these as planning numbers. If a shop quote lands near the top of the range, that’s fork money, not the common job — ask which test failed before authorizing it.
Typical price range
Parts$100 – $500
Labor$100 – $400
Varies by underlying cause - often a sensor, connector, or wiring repair. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.
Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.
What will this cost to fix?A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P2110 ranked, each with a price range. They handed you a printout at the parts store? Decode it before you buy.
DIY difficulty
3 of 5 — Reading all codes and researching TSBs is DIY-friendly; the underlying fault may need professional diagnosis.
Who's behind this guide?WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes.Read the full methodology →