P20E1

P20E1: Exhaust aftertreatment fuel pressure sensor circuit intermittent/erratic

DIY difficulty 4/5

Print shop one-pager Take this page to the shop — causes, fair prices, and sharp questions on one sheet.

On your diesel, the pressure sensor on the diesel exhaust fluid supply circuit is cutting in and out or jumping around. The aftertreatment system could be damaged if this is not fixed.

Key facts

Symptoms

Likely causes

Too many suspects? Answer 4–6 quick questions and this page's published cause list re-orders itself for your situation — plus the cheapest test to run next. Start the elimination wizard →

Before you buy the part — 6 checks

Work these checks before spending money — each one rules a cause in or out, cheapest first.

  1. Check for technical service bulletins for your vehicle.
  2. Visually inspect the aftertreatment wiring harnesses and connectors for loose, burnt, or damaged wiring - wiggle the harness while watching the sensor signal. Tests: Loose connector or chafed wiring in the aftertreatment fuel pressure sensor circuit (most…
  3. Retrieve all codes and freeze frame data, clear the codes, and test drive; the code may reset immediately or only after conditions worsen.
  4. Voltage-drop test all aftertreatment fuel supply system grounds and test the power supply to the control system; test fuses with the circuit loaded. Tests: Loose connector or chafed wiring in the aftertreatment fuel pressure sensor circuit (most…
  5. Test the aftertreatment fuel pressure sensor and its circuits against the manufacturer's specifications - do not forget ground circuits.
  6. Test the aftertreatment fuel supply pump against the manufacturer's specifications.

No scan tool yet? The Veepeak OBDCheck (~$32) reads and clears codes from your phone in about two minutes.

Typical price range

Parts$100 – $500
Labor$150 – $400

Aftertreatment fuel pressure sensor or supply pump replacement. National-average estimate for the most common repair for this code. Actual quotes vary by vehicle, region, and shop - get a local written estimate.

Dealer vs independent shop: these ranges reflect typical independent-shop prices. A dealer will usually quote higher — higher labor rates plus OEM-only parts — so a dealer quote at the top of (or a bit above) this range isn't automatically a rip-off. For a big dealer number, get a second quote from an independent shop before authorizing the work.

Got a shop quote? Grade it →

What will this cost to fix? A code doesn’t name the repair — run the code-first estimator to see the most likely fixes for P20E1 ranked, each with a price range.
They handed you a printout at the parts store? Decode it before you buy.

DIY difficulty

4 of 5 — Inspecting connectors and wiring for looseness and damage is DIY-friendly; tracing an intermittent signal needs a scanner and wiring diagram.

Watch this repair on YouTube

Parts & tools

Sensor replacement toolkit — what the job actually takes

Torque specs: Sensor mounting bolts: typically 8–12 Nm — verify spec. Never overtighten sensors with plastic bodies.

Pro tip: Check wiring and connectors first — chafed wires and corroded pins cause more sensor codes than dead sensors do.

As an Amazon Associate, WrenchFair earns from qualifying purchases.

Related codes

Check another code
Got a quote?Grade it →Shop one-pagerPrint it →Another code?Look it up →
Who's behind this guide? WrenchFair is built by a fellow DIYer, not a repair shop. Code meanings follow the SAE J2012 standard; cause rankings come from real-world repair evidence (service bulletins, owner reports, NHTSA records); prices are typical US ranges, not quotes. Read the full methodology →